Tacoma DRL/ Turn signal with switchback LED

Hi eveyone,
I've just installed a pair of LED switchback to replace stock bulbs and added resistors to them to correct the quick flashing from turn signal. When I connected the sliced connectors (one side with the light blue wire and the other with the white and stripes wire), I turned the switched to parking mode, the LED worked perfectly, WHITE and then AMBER flashing when I turned signal on. When I turned to full headlight, it still stays WHITE and I am happy with the results. However this morning when I leave the switch at DRL and drove to work, the LED stayed at AMBER, turn signals working normal, there was no issue there. Now, the only time they will turn to WHITE was with the headlight on.
Is there any expert advise for this or it's just normal? Or I might connect the wires the wrong way, should I reconnect the resistor with the GREEN, instead of LIGHT BLUE?
Thank you for any expert advise on this.