Fabtech 3.5 install questions

The add a leaf has a plastic tray, does that go above or below the add a leaf, second question the hole is off center, so does the longer part of the add a leaf go towards the rear?

Thanks about put truck on jack stands and get started.

 

The longer part of the leaf should go to the back. I think the plastic piece should go under the AAL but no completely certain

 

Got the surface rust cleaned and painted. The pocket above frame and below strut mount is a horrible place for rust to form. Was going to put frame Saver paint but I had a can of spray paint in my building. I also am ready to bolt up the coil overs and see how it looks on the ground!

 

Plastic goes in between aal and the leaf above it.

 

Thanks devinzz1, the back will be done next week. With the front on the truck sits only slightly higher than the back.

 

Can you post pic of plastic piece

 

It is a thin metal tray with a plastic lining inside.

Took some measurements after a couple hours of driving. I got about 1.5 inches lift, maybe 1.75 on passenger side. There is still plenty of threads on the collar to adjust them up. The CVs are not angled bad as of now. Where can I purchase a spannered wrench?

 

Sorry i was thinking of the plastic sliders that go on each end of some leafs. Not sure if it goes on top or bottom but i would say the bottom.

 

So I called Fabtech and they say that the plastic plate is not part of their kit. I did get this kit used, so maybe this is a factory Toyota anti friction plate?