*Sold* 2010 Access Cab Tacoma 4cylinder 5speed Manual

Batting around the idea of selling my 2010 Tacoma and finally came to the conclusion that a bigger truck is needed since getting married next year and a family is coming pretty soon after that.
It is a SR5 Access Cab with the 2.7L 4 Cylinder and the 5 speed Manual Transmission. Right now about 126,xxx miles on it and will go up since I daily drive it and go on road trips with it as well. Only real reason for selling is been looking at a 2016 and wanting to get something with less miles since I do road trips from Michigan to New York at least once a month.

I purchased the truck in January 2013 certified used. According to CarFax I am the 3rd owner but actually I'm the second. My father purchased the truck for me (2nd owner) and I paid/worked it off and he signed the tittle over to me in July 2014

Maintenance:
Oil Change every 5,500-6,000 miles with Mobile 1 Full Synthetic (0W-20 in the Winter and 10W-20 in the summer) with Mobile 1 Extended length Gold Filter
Coolant Flush Done at 100k miles by Haddad Toyota in Pittsfield MA
Bosch Double Iridium Spark Plugs replaced at 100k
ECGS Front Diff Needle Bearing Replacement with Bushing done at 80k
Rear Drive Shaft U-Joints and Carrier Bearing Replaced at 120k
Front Pass CV Axle replaced (torn inner boot around the axle shaft) at 110k
Front Driver CV Axle Replaced (torn inner boot around the axle shaft) at 124k
Front Outer Tie Rods Replaced at 124k
Front Bump Stops Replaced with Wheelers Super Bumps replaced at 124k
Front Brakes (Pads and Rotors) done around 75k due to a warped rotor
Transmission Oil Change with RedLine MT90 done at 40k/80k/120k
Front Diff/Transfer Case/Rear Diff oil change done at 40k/80k/120k
Air Filter is an AFE Dry Drop in Filter
Headlight Bulbs replaced at 120k
Driver Front Lower Control Arm replaced (Bad Ball Joint) at 80k
Passenger Front Lower Control Arm replaced (torn Ball Joint Boot) at 95k
Driver Side wheel bearing replaced at 80k

Extras/Aftermarket/Upgrades:
16x8 -10offset Level 8 Mk6 Rims
265/75/R16 Goodyear Fierce Attitude MTs (bought in September approx 30k on them with about 50-60% tread remaining)
Camburg Uniball Upper Control Arms (with spair bearings)
Rock Krawler custom front Coilovers. 60/70 Valving and 650lb/inch coils
BAMF Rear Shock Relocation with 13 inch travel Rock Kralwer 2.0 shocks 60/70 valving
Dakar Rear Springs
Rear Extended Brake Lines
Front Extended Brake Lines (not installed)
Custom Tool Box to fit level with the top of the bed
Tow Hitch and 4 pin wire harness
4x4 Spod Switch Panel with 6 switches
32inch light bar mounted in the front
2- 2x2 LED pods in the rear
CBI Ditch Brackets (Driver mounted, passenger side waiting to be mounted)
2- 2x2 LED pods for the Ditch Brackets
CBI Bolt on DOM Sliders with Kickout
Front Pelfreybilt Aluminum IFS Skid Plate
Weathertech front Floor Liners
2 sets of Factory Carpet Floor Mats
1 Set of Weathertech generic Rubber Floor Mats
Coverking Front Neoprene Seat Covers
Genuine Tacoma Bed Mat
6- Tie Down Cleats
Front AVS Bug Shield
AVS Rain Guards on the doors
Total Chaos Alignment Tabs (not installed yet)
1-Spare Toyota Factory CV Axle (needs to be rebuilt but makes a great spare)
BAMF Rear Tailgate Antenna Bracket Driver Side

Probably a few extras that I am forgetting about as well.

Trucks has severed me extremely well over the last 3 years but with a potential growing family and the need to have something with lower miles, I have to let it go to a new loving home. This will be an excellent truck to start learning on or for someone who want to cruise around town. My Tacoma has never left me stranded on the side of the road, never stuck (battled numerous snow storms) and has made dozens of trips halfway across country. Has always started in the morning and hand on heart I would not hesitate to drive this thing anywhere. It has been taken offroad, but nothing serious, some field cruising and beaches, but never beat or pushed beyond its limits. Has a clean title with no accidents.
Truck will be located in Ann Arbor MI right now, but in 3 weeks moving back to the Albany NY area.

Hopefully still have you after this long ad but I am asking $17,000 for the truck with everything listed above (that's with everything cleaned and any and all maintenance items done till time of sale). Stickers will stay on unless the buyer wants me to remove them.
I prefer not to part the truck out since right now I can't deal with that hassle and I just dont have all of the stock parts anymore.
I attached some photos but more can be found on my build link or if you want message me and I can send you any particulars

 

Updated Asking price. Also open to offers

 

So to update the truck is now officially for sale. asking price is above but $17,000 OBO. Tacoma is currently in Michigan but I will be moving back to New York in 3 weeks

 

Bump. Moving Back to NY this weekend so truck will be located near Albany. Looking at a newer Tundra this weekend, so open to offers. Thanks!

 

Bump for a nice truck and a good seller.

 

Truck is sold. Traded it in for a new to me 2015 taco