34's on 3in lift?

Im trying to figure out if i can fit 34's with a 3in lift. i have stock wheels with 32 10.5 and i have like a 1/4 inch between my uca and tire so im gonna get 1 1/4 wheelspacer and hopefully fit 34's 11.5. has anyone else done this. will it work without a ton of trimming?

 

Do you mean 33's? Either way...I wouldnt go over a 33 with a 3" lift for a couple reasons 1. you will have to tub the fender/body 2. you will definitely need to re gear for anything over a 33.....actually a 33 would be best with a minimum of 4.56, but 4.88s would be good to.also the stock wheel is only 7" wide so you wouldnt really want to run a tire wider than 10.5, so best bet would be get some 16x8 wheels

***EDIT*** if you get wheels with a 4.00 BS you wont need the wheel spacers

 

i really want 34's but i wasn't sure if it would work. after looking it over i don't see why it wouldn't. and the guys at discount tire said i could go up to 11.50 on a 7" wheel safely. i am gonna eventually get around to regearing it anyhow. also i read somewhere my stock wheels already have 4.5 bs

 

Youl have to do a "mini" tub, cutting out a section at the rear of fenders. At that point its just aswell to go 35s imo.

 

tub as in trim? what size tires do you have

 

Tub as in cut out the edge and reweld in a flush piece to allow clearance. http://www.yotatech.com/f2/tubbing-tacoma-35s-222863/

You wont have to cut as much with 34s but you will have to.


I only have 32s till i regear for 35s.

 

what rai

what ratio do you plan on getting?

 

Probably 5.29s as this truck probably wont see much highway use.