285 75 16

Putting a 3 in leveling lift will 285s rub in the inside of the fender at all when turning.

 

What year truck? What wheels? Offset?

 

Yes, 285s will rub pretty much no matter what, until you trim and cut and hammer stuff. You'll rub a little if you stay on road, but once you compress that suspension i.e. turning and hitting a dip, you'll rub. The way to remedy this is to trim plastic, hammer some metal out of the way, and cut some other metal out of the way.

 

2013 not sure offset got them used. tires stick out about a inch when on the truck

 

Eatsleep is right though. You're likely going to rub.

 

What's the best thing to use to cut the fenders for a clean cut and I don't think there's any metal jus plastics on my 13

 

You'll hit the cab mount. Big steel block at the bottom of the fender

 

No, there's metal in there. Look at the CMC (cab mount chop) and hammering the pinch weld. It is hiding behind plastic.

 

@Aussiek2000 Damn, we're on a roll!

 

I rub with 3" lift and 255's. I'm going to cut the cab mount and reweld it when I go to 285's

 

Any vids out there

 

They make dremel blades made out of metal that are perfect for cutting plastic.

 

Yeah, I'm picking up some 285s over labor day. I've already got my CMC plates ordered.

 

How much are cmc plates?

 

I got them for $17 from BAMF. You have to cut off part of the cab mount with a grinder, and weld these in it's place. Some people just cut it and leave it open, but I recommend against it.