What have you done to your Tacoma today? 1st Gen Edition

Anyone know the best place to find torque specs?

 

The repair manual probably

 

What's specs do you need?

 

Front shocks, u bolts, rear shocks, etc. do you have them or have a fsm?

 

If no one chimes in I do have a fsm and can look it up for you in a little while.

 

I dont know if these are big enough to read...



Bottom one is 4wd, top is 2wd

 

Bought my 1st gen yesterday <

 

Yeaaah buddy! Welcome aboard.

 

Welcome to TW!

 

This is what i used when i did my lift swap

 

Is the torque for the u bolts the same if you did a u bolt flip?

 

Yea, that's what I did.

I got a p0171 code on the truck checked vacuum lines, cleaned maf, check to see if the o2 sensors are getting voltage. But the truck runs fine when it's warm. But when I first start it and it's cold every gear change its a noticeable sluggish and down on power. I put fuel injector cleaner in it and ran it 50 miles as well no avail. Kinda stumped

 

Dude I had a po171 on my 99. I tried to fix it for like 6 months and nothing worked. A kid came along and totaled the truck before I got a chance to solve the po171. To this day I think I may have been an issue with the fuel pump.
Cuz I changed the fuel filter, plugs, hoses, ran injector cleaner, cleaned maf, cleaned throttle body, changed both o2 sensors

 

Mine was similar to that and it ended up being the sensor needed replaced not just cleaned.

 

It started happening when I put my new air intake on so it may be the culprit. I'm pretty sure the o2 sensors are good but I'll get them and a maf this weekend. So I might be able to narrow it down some more by that time. I hate this code though lol cause it could be literally a dozen things.

So maintenance list is fuel filter, both o2 sensors, maf, timing belt kit, clean the throttle body.

 

Pulled my rear axle so I can get a new bearing pressed in/all new seals. The play was bad.


http://vid75.photobucket.com/albums/i314/wings_of_fury/CE1F376B-9046-4C46-B50D-914E799086B7.mp4

 

Same code as well. The only issue I have is when it's warmed up, and I'm sitting at a stop. It will have a slight sputter, but never dies. And it doesn't happen all of the time.

 

Does it Rev up and down as you come to the stop. Cause it did that to me and the idle air control valve was sticky

 

33' duratracs and alignment today.

https://www.tacomaworld.com/threads/roadsurf88s-2004-tacoma-ext-cab-build.446959/#post-13060136

 

I am officially boosted. Please excuse the overcast evening, haven't seen a sunny day for 2 weeks.

Supercharger install!



2.2 URD pulley w/ upgraded dynamic tensioner.



Here's the 7th injector.

And the URD 7th kit controller.