short.people.del.taco.build - mall crawler edition (TRD Sport DCLB)

does the camera have to be PAL/NTSC capable or will just NTSC be ok?
wondering if this camera would work

Backup Camera, Esky Ultra HD CMOS Car Rear-View Camera 170° Wide View Angle Waterproof Reversing Camera with Super Night Vision for Pickup Truck Car Large SUV Minivan Tractor Trailer Van and Sedans

https://www.amazon.com/dp/B005Q65JHM/ref=pd_luc_rh_sbs_03_01_t_img_lh?_encoding=UTF8&psc=1

 

@Joe23 It's PNP - Pull out the HU (remove the bezel and it's 4 screws!) and plug it in, that's it.
@dzkritzas You can use any device that can connect via composite or HDMI. You'll want an NTSC camera as that's what the Crux is programmed for.

 

Any pics of the install is much appreciated new to this. Connection of the cabling and all. Also where did you get the power for the camera please helpppp

 

That CargoGlide builds nice stuff should last you forever

 

I need some your wisdom and knowledge with the Vimty-05 interface. I have a 2016 Tacoma dclb, I hooked up the 28 pin and it displayed the av icon on the non jbl head unit. I did not hookup the 16 or 10 pin connector pieces and was told I could cut the red,yellow, and black on the 10 pin and use them to power the camera up front. I could not get it to work and also realized I only have a 4 button paddle to control the volume and am, fm, xm. Do I have to put in a switch for the camera hooked up to the orange/white wire? And what rca input, red,yellow, white do I hook the camera to. This sounded so easy

 

Sub'd

 

I was considering adding a front camera and a rear view load camera inside the crew cab looking out into the bed. Through the it would be easier to mount on the top of the fabric ceiling. Just wondering if anyone has done this with their Crux VIMTY-05 work.