My Build Thread v3.0

Mmmm rebuilt coilovers

 

So haven’t updated this in a while. Kind of hard while being in Korea and can’t touch the truck. But I did some stuff.
Installed shocks and bump stops



And I busted out my left taillight back in 2015 and finally replaced it with these


Got more to do on my GX 470 soon.

 

Dude!! This is your truck?! i remember watching this build a while back and was gonna ask you something, but noticed you had been gone a couple years. Glad you're back, sick build

 

havent been gone, just dont post up alot and havent done anything significant to the truck to update this thread until now.

 

You still running the stock clutch, or did you upgrade? didnt see that on p.1

 

URD twin disc clutch. ballin' status

 

What's that rated for torque-wise?

 

supposedly "The clutch will be rated for 800 lb-ft of torque"

they dont seem to be on the URD site anymore.

 

OG build. truck looks good

 

800 ft-lbs, the taco is like 100 ft-lbs lmfao.

So how did you replace the rear shocks on the truck all the way from korea?

 

Umm got back from Korea over 2 months ago

 

pffft, get back to korea

 

Eww no

 

Finally, Did this. Don’t wanna ever do it again. Sucks. Hated every minute of it and template sucks and didn’t line up for shit. But snorkel finally installed

 

Repainted lid to toolbox. Was peeling really bad

 

Installed a new o2 sensor. Been having a p2241 for probably about 4-5 years now. It would pop up as pending almost every time I ran the truck. Clear it and sometimes it would pop up again sometimes even trip a full on code. Clear it and wouldn’t come back while driving. So glad that’s cleared up now. Was annoying having the ultraguage alarm go off everything starting the truck.

Also was having a growing in in the front end so replaced both wheel bearings and everything is nice and smooth and quiet again. Second time replacing the wheel bearings. Been getting 6-7 years out of them

 

Did a thing. Had to remove the steel sleeve for the throw out bearing and that sucked. Sucked trying to get transmission reinstalled. Also replaced the fj case. Old one had a crack in two places and leaking. Also won’t be twin sticking this one. Don’t feel the need.

also got a oil cap too

 

Got my single shift fj case shifter bent back to the right spot after putting in a new tcase.

 

So i was having a P0304 code popping up when i got into boost then turned into p0300. so figured it was either a spark plug or coil pack. decided to replace all spark plugs and also the coil pack on cylinder 4.

All plugs were gapped between .045" to .055" the manual for the supercharger states .032" below is pretty much what all the spark plugs looked like



also i cleaned up the supercharger and adjusted the boost valve on it. everything is better and it feels like it runs better and pulls better when in boost now.

 

nice build man.....