Second Gen Snugtop Rebel owners, I have a measurement request.

I posted this over in the Second Gen forum, but this maybe a better venue.

https://www.tacomaworld.com/threads...e-a-measurement-request.463171/#post-13786364

---

Snugtop Rebel owners,

I hope you guys can help me out. I will be placing an order for a Snugtop Rebel next week... I have a set of ARB drawers installed in the Tacoma and want to ensure my ARB fridge will clear the upper portion of the rear door opening when the slide is pulled out. I've ran the numbers on paper and its going to be close - ~1"; with that being said, I have a measurement request for those of you who have a Rebel installed on your second gen Tacoma.

The measurement I need is the distance between the upper door opening (below the right side hinge) and the base of the bed below the door opening. I have attached a photo from Google with a quick sketch of the dimension I need measured:



Thanks in advance. I really appreciate the help,

-Stephen

 

31" on my Snugtop Rebel. This is measuring from the highest point of the bed (top of the groove) to the carpeted lip at the top of the opening.

Keep in mind this measurement will be smaller if you are using a bed mat.

 

Thank you! Exactly what I needed. Much appreciated,

 

@The109 - did you leave your black plastic bed rails installed under the shell?

 

I didn't remove ANYTHING prior to getting the shell installed. The shell gets clamped to the truck via the rails and some little clamp connectors. You're going to want to keep the rails in there. If you're talking about the plastic covers on top of the bedsides, yes, I left those too.

 

Good deal. Thanks for the quick response.