ETxTacoma's Dynatrac ProRock 60 Rear Build and BS Thread

I'm slowly building EAF points... it's a process. I cannot wait to get back up in the mountains with the truck's new goodies. I couldn't pull the trigger on the discounted ARB fridge last night though

 

I will try my best, going to get some Christmas shopping done hopefully. I have to be back in Tyler by like 10:00 to attend a Graduation at Tyler Junior College....

But so pricey!

Ha, I went out to take off the other Ditch Lights and wore some PJ pants under my jeans, then a mexican sweater, and a vest. I have to get acclimated to this cold and then next thing I know I am wearing shorts.

Hate them, had them once and gave them to a friend as I thought they were gross.

Yep, will really be full EAF once I throw on the 6ft and 4ft awnings and also wire up the Reverse/Camp lights off the rear as well!

 

Am going to drop of the bezels tomorrow to have them powdercoated the same as the bumper. Wish I could repowdercoat the entire light housing though. They have a couple nicks in them and have faded some.

 

Dead.....

 

Nope, was pretty busy most of the day.

Went to Terrell this morning to go to Buc-ees, got some Christmas shopping done and sold the Lightbar, Pods, and Bed Light Kit.

Then had two graduations to attend at Tyler Junior College, one at 10am and one at 1pm. Then when I finally got home, had to go meet a guy and sell a pair of boots to him. Finally was able to get back home around 5pm and then went to sleep until 10.

Am now at work and will be here until 1pm tomorrow...

I did get the new Amber lenses in for the Fog lights, so instead of the Driving/Combo that I had in there, I put Wide Cornering and I like them a lot more, way better for fog lights instead of the spot that the other had.

 

Think I may try and do the sway bar delete today... and install the new Baja Design lights on the Ditch Lights.

Need to stay away so I can go to bed at a normal time tonight.

 

Do etttt

 

I want to see some output shots of the BD's

 

Still have about an hour and 15 minutes left at work. So will see how I feel when I get home.

Need to get the ditch lights wired up so all I have to do is connect and mount once I get the bezels back.

 

Of the ditch lights or the fogs now that I have the different lenses in them?

 

Boths. Lol

 

Once I get the ditch lights on there then I shall. The new lenses in the fog lights work so much better, the spread is perfect for fog lights.

I just need to figure where I want to aim the ditch lights as they have both a spot and the wide cornering lenses in them.

 

When I had mine I didn't have them straight they where at an angle outward.

 

That is how I had the other ones, angled outward but also pointed down. So with these I may angle them outward but not downward at all since the bottom half will cover the ground.

Took the bezels yesterday to have them coated the same as the bumper. But realized when i got home I should have had the actual mount done as well, so they would all be black. But oh well. At least the bezels will be black.

 

Hey just rattle can the mount

 

True....

Bezels are done, going to go pick them up after work and get the new ditch lights installed today.

 

New ditch lights are installed, so much brighter than the Cali Raised pods. Can't wait to get some good night shots with them.

 

You take sway off?

 

Phase 1: Remove sway bar
Phase 2: ...???
Phase 3: Profit.

Your IFS will be all like