Magnaflow Crew Cab Exhaust on Access Cab

I just picked up a 2006 Tacoma TRD Access Cab. The Muffler is shot and I figure this is a great time to upgrade. I have found a Magnaflow Exhaust #16625. Looks like it is for the crew cab. I am wondering how hard it would be to put this in an access cab? The owner says I only need to shorten the mid pipe, and the hangers should match up just fine. Any experience with this?

 

http://www.magnaflow.com/products?partnumber=16625

 

Dcsb exhaust in about 8" longer from the y pipe flange to muffler. you should just be able to cut it. when I put my mbrp on is said it was for Dcsb and access cab

 

I took the same 8inch and cut it. dumped it in front of the axel. Wish I never did. The grawle is so dam loud between 1500 and 2500rpm in yhe cab. Sounds bad ass at 3k plus. But not worth the noise aggravation

 

I put it in today. Fit perfect. No cutting required. I guess this is good for crew cab short bed or access cab regular bed.

It is very quite, even under load. Maybe it will waken up a little after use. But I am happy. Just what I was looking for. I would highly recommend. No drone at all.

 

This came out right behind the rear wheel, just like stock. It's pretty slick!!