BAMF CMC plates (Cab Mount Chop)

Will this fit 35's?

Ive been running 285's for a couple years without any rubbing on the cab mount. 2.5" of lift. 4.30" backspace. Not an issue with my truck im not sure why but im not complaining.

Will these CMC plates work for me or will i need to cut more?

 

You'll likely need to cut more.

 

You will most likely need to cut the tip off of the cab mount to properly clear 35's. But if your saying you have 285's and don't rub your not fully stuffing the tires because a 285 fully stuffed to the bumps you will hit the fire wall so you might be good for the driving your doing. .

 

I dunno man shes not a pavement princess. Ive tucked my tires as much as they'll go turned at all angles, all rubbing issues ive had were on the fenders and pinch weld. Hacking and hammering have taken care of that.

So if i cut the tips off will the bamf plates still be useful or will i need something else?

 

Are you running sway bars?

 

Not as of a few months ago. What do all the other guys running 35's do to their cab mount? I know LT guys with 37's have to relocate it and tub the firewall but as far as ive seen no one has to with 35's.

Toyota needs to get their shit together and make the wells big enough for 37's from the factory.

 

A lot of fender cutting and beating of the fire wall.

 

Order received. Thank you.

 

Finally set my camber with my new Uca. Now I rub hard with 33s and a 3" ome lift. Do you think the cmc will clear my 2.6* caster?

 

You won't know until you cut it off your still rubbing after your alignment needs to be changed or different wheels and tires.

 

im ordering some today. I'm only getting rub on almost full turn.

 

Post Weld Smoothing Out The Rough


Paint


Thanks to my homie E for the install.

 

Ordered the CMC plates and a CB mount! Looks like a 20% sale is going on now - site wide

Thank you!

 

Are the plates for the 05-15 tacomas the same for the 2016s?

 

Yeah

 

No they are not the body mount is completely different on the 2016+ trucks.

 

Well. My bad.

 

Ordered, Thanks!

 

So I have 265/75 on my 05 Tacoma pre runner. I only have a rub when it gets close to a full turn or turning into a driveway. Would this be the solution for me? If so what kind of shops should be able to do this/understand what I'm trying to do?

 

Yes if done correctly you should clear just fine. As for the install any off road shop should be able to handle it.