Your unique mod on the 1st Gens

Not sure about a 1995 Tacoma, but it is possible. My '98 was pre-wired for CC but didn't have it as an option. It took me quite a while, and a lot of research, to source the parts.

In my case, I needed the actuator, computer, control switch and brake switch (all OEM parts). I got all of them from various wrecking yards. It looks and works like factory. All the connectors were there, just not plugged into anything.

Mine has a 2-cable actuator, yours might have just one, not sure.

 

Before and after on my 01 tacoma ... sorry pics suck

 

Great lookin truck! One question though, is your light bar upside down? Never seen one curved up like that before.

 

No just have it pointed down cause it whistles like crazy while your driving unless u point it all the way up or all the way down

 

Put rubber trim piece on the bottom cooling fin.

 

Yea that's what I was thinking on doing just gotta have the time

 

Cut some iJDMtoy (Amazon $39.99) flush-mounted LED's into my rear bumper. Used an angle grinder with a 4" wheel, then bolted them in with stainless steel allen head bolts and nylok nuts. T-tap into green reverse light wire, shrink tube and done.

 

What lift u running?

 

Installed a overhead console from a mid 90's suburban without overhead AC controls . I had to take down the headliner to make a custom bracket and run wires to the LED map lights. It covered up the factory door/courtesy light so I put in a LED light behind it and wired it with the factory door wires to come on when I open it.
The fit was pretty good but I took the funky cloth along the edges off it and trimmed it some to fit better. Just primed gray now but will wrap it or paint it when I take it down again when I install a CB up there.

 

That is an awesome mod right there. Great idea.

 

Bought mine off feebay for like 60-70 bucks last year but plenty in junk yards too. Like this one on feebay is the exact type I bought... and you can see the funky color tan cloth I took off.
http://www.ebay.com/itm/92-00-Chevy...Console-TAN-/272511524131?hash=item3f72f3dd23

 

Thats sweet. No pics of the brackets you made i assume?

 

Beat me to that one, was just typing that lol

 

No ...sorry.I was in a zone. I will shoot some when I take it down again.
You basically have to only make one 2 inch bracket with a nutplate coming off the front roof crossmember behind the mirror to attach the front and the console has 2 wide plastic hooks or brackets that tuck into the rear roof crossmember when I cut holes for them .Had to cut holes in the headliner though so there's no going back.

 

Well done. Looks clean.

 

Installed a marine USB/cigarette box into the bed. 10 guage wire should handle the invertor. That and the bed lights are wired up. Next is the bed liner...

 

What size are the light bars?

 

output shots pls

 

Wheel and tire specs ?