Trd grey supercharger 3.4 Tacoma , where to find gaskets?? For Rebuild

I have a Trd grey supercharger and I'm going to do a rebuild on it.

The only parts I can't find are the gaskets that are for the large tube that goes into
the charger in the rear and then has a right angle going down.

Both these sections are loose as the gasket is worn out. I'm thinking
they are an O-ring type gasket?

Anyone know a part number or where to get these 2 gaskets?
Or how to remove this section??

I had to use a liquid gasket covering up the seams because of vacuum leak.

Thanks

 

I'm looking into this.

So that elbow is not supposed to move then? Mine does.

Could be my issue. I've seen a couple now that have had black seam sealant put around it. Is that what you did?

 

I had the charger rebuilt and that part was fixed at that time, this was an old post, is an easy fix, just unscrew the bolts that hold the tube, gently
slide it off, there is an o ring rubber gasket, clean and replace and use gasket sealer with the o ring around the tube where the o ring is and your good to go. If you use gasket sealer the tube will not move.
If you just replace the o ring gasket then there is some play
I would use the black sealer for a better seal

 

I've seen a couple just done like this to stop it from moving I guess.



Also had a guy tell me he had a plate cut where the bypass actuator goes as it was leaking.

 

Yup, you can do it that way and it looks like crap or spend 15 minutes and take the tube off
and seal it from the o ring seal area, )

 

I shall do the latter haha

 

Yea, keep it clean looking, not a patch job,

 

Did you find that the plate inside by the actuator was too small and leaked?

 

No, my leak was on the top part on that o ring, I'm guessing the bottom part would be the same.
Either way its very easy to take off and fix, 4 bolts and maybe a clip, when I have my charger rebuilt
3 times now over 525,000 miles I have all these gaskets replaced each time