303tacoma Keepin it Simple

So the switch is in...
I took advice from @YamaDirtrider @mountainmonkey and I shot a pm to @Iggy awhile back since he made the harness the light bar came with..
Thanks guys
The lower light on the switch stays on at all times but I doubt it will hurt anything,pretty much like my alarm led I would think..
If not somebody give me a heads up!!!
Ya and I know it says spotties for a light bar but hey the switch was free

 

Ok pictures as promised
I'm going have to aim it down a little, spot is kind of high

 

Might be just me but is a little left as well, no?

 

It looks like it in 1st picture but don't know how that's possible its centered behind grill..
I'll double check though
Should the light be aimed a little below headlight cut off or above???

 

With that bright sombich I would do a little above the headlights so you can see errthang

 

I'm having this same problem with my switch, scouring the forums for answers. has it drained your battery at all?

 

No and I let my truck sit all week.
My switch is only 3amp.
Just need to tap into a wire for illumination and fuse tap to trigger switch with ignition on,instead of running all the wires back into the relay where they are hot all the time. Here are a couple threads I have found useful..
I've been lazy about it.
https://www.tacomaworld.com/threads/how-to-secondary-stand-alone-fuse-block-install.120561/
https://www.tacomaworld.com/threads/wiring-an-aux-fuse-block-relays-and-switches-in-a-2016.401253/
And a discussion with a few of the colorado guys

https://www.tacomaworld.com/threads/colorado-b-s-thread.131441/page-5218#post-13642326
And finally here is a picture of the illumination wire coming off fog lights



Hope this helps

 

Took a few more light pictures where it's dark out by where I work
Darkness
Lightbar

Lightbar

Just the Fogs and headlights


Headlights lightbar

 

This is awesome thanks

 

This just in

 

​

 

oops!

 

Ya haha he's a bit of a daredevil

 

No harm done it looks like though. How are the approach angles with the Iron Cross bumper? It looks to hang a bit low IMO. I just recently installed the flat top Demello bumper. I have yet to go out and use it though.

 

I would assume not very good it's huge and john gets roughed up a bit with pictures such as these

I like the demello bumper
Nice truck!!
Stop by the bs thread I dont think I've seen you in there before
https://www.tacomaworld.com/threads/colorado-b-s-thread.131441/

 

Thanks.

 

Cooper St Maxx ordered today
of course not in stock
Keepin it simple guys

 

size matters.

 

Maybe but I don't want have to chop a bunch of shit or pound a bunch of shit.. I just want to have some fun on the trails

 

Once you make that first cut and bash that sheet metal, your definition of fun will change.
what size did you get? I must have missed it.