3rd Gen Tacoma Lean

Is there a thread on this already? I have not had a lot of luck with searching in this forum. I have been spoiled with other forums with good search options. Like you can search each individual area. I don't see to see that hear or I haven't gotten it figured out yet. Anyways my truck is about 1" higher on the passenger side I believe it was when I checked it. I do have coilovers now, but not sure I want to correct it with them as it changes the suspension to be different that side right? Anyways if you have thoughts or fixes please let me know.

 

Search would yield better results if you use Taco lean. Also if you are in the 3rd gen sub forum click on, this forum only.
Anyway, to get you started.

https://www.tacomaworld.com/threads/does-it-lean.393022/#post-14816335

Edit: its not a new thing for tacoma. You could find info in the 2nd gen sub too.

 

When measuring make sure you go from the center of the wheel to the bottom of the fender, that way airbrush or will not affect the reading . I would also measure probably with a half a tank a gas

 

Thanks for he information. Not much in that thread though. I measured from the ground to the fender. I may go and check again since I have posted to verify. I wanted to post in the 3rd gen forum since I have a 3rd gen was all.

 

Look at your truck from the back ... stand back 20 feet or so and see if the bed lines up with the roof... looking to see if the bed is no level with the roof line. If thats the problem some body mounts are worn or out of alignment. Taco lean is less that 1/2 inch not even that much.

What made you measure?