Using a die

I don't want to purchase an entire set of die and taps. I just need a bolt to be re-threaded on my Tacoma.

Is it possible to use a regular wrench with a hex die? All the video of people using a die has been with this

To do this as cheaply as possible, can I use a wrench to do the job?

 

So you're just wanting to chase threads that are buggered on an existing bolt?

Where do you live? Maybe someone can help you out.

But depending on the die you are using, a wrench should work fine.

 

Maybe a thread file can help also and is fairly cheap and can really come in handy

 

Yes you can just use a wrench, just take your time and ensure the die is going on straight and not cockeyed.

 

Be sure to get a chase die and not a thread cutting die

 

I would get the die and the die tool. Die tool allows you to put even pressure and is easier to keep aligned.

 

Ive been using one these for years to fix bolts. Doesnt do the best right at the point but will fix most threads. Also can be used again on multiple bolt sizes. guess it depends on your need.

 

Would it be cheaper to just buy a replacement bolt?

 

Then he would just have a replacement bolt and not a cool new tool.

 

At this point I would have a new bolt if at all possible

Even Having all the Tap and Dies Thread Chasers etc

My first choice would be a New Bolt!!

 

If it was to replace the O2 sensor. The bolts are welded on so that wasn't an option. Hex die and a wrench work perfectly.

I hate having to purchase highly specialized tools because while I do a decent about of DIY work on my Tacoma it still doesn't justify $15 for a set of hex die.

 

Just FYI those are studs unless someone welded them fast.

For these I don`t mess around I tried all the repairs the fastest is for me to just remove the old bung and well a new one on.

Most times the studs just snap off or are so rusted cleaning threads is impossible

 

1)Borrow/bargain/blackmail Someone to fix it.
2)buy a new bolt
3)buy a small file set (I've cleaned up hundreds of boogered up threads with files) helps to wire wheel the threads after filing to clean and smooth out.

I'm the type that looks for any excuse to buy new tools.

 

I hate buying tools The First $250,000 .00 was not to bad it was the last $10,000 .00 that seemed expensive

 

I'd spend millions if I could.