What Have You Done To Your 2nd Gen Tacoma Today?

I had to scrub the bed of my wifes truck because I made the mistake of using her truck to transport my chainsaw after felling some trees at my parents. A little bar oil got on the cheap plastic bed, now it's degraded the bed a little and the plastic is sticky. Should have used a real truck.

The chainsaw was back there for two days. Maybe it's my fault.

 

Put in some PIAA Ion Yellow fog bulbs.

 

Anytime buddy!

 

T-25 worked for mine.

 

Today I cleaned the throttle body. I wasn't planning on removing it but after I saw how the tooth brush was not cutting it, I decided to remove it and clean it properly. 10/10 would do again.

To sum up the sonbabitch was dirty af

I also used seafoam to top everything off

And, cleaned up the engine a bit... Oh..and I found a surprise in the engine compartment too. This is why I hate Chipmunks and mice

 

Death to all chipmunks! Looking good. I need to check my throttle body as well.

 

Most important mod ever.... bed side bottle opener. may need to clean up those bolts though

 

A red storm trooper!!

 

.. or perhaps Imperial Guard?

 

Aired up the tores after taking through a trail earlier this morning...



Basically fully tested put the new tires. Trail got washed out in a few spots pretty bad, but RR DIFF LOCK FTW!

 

Just a regular wiring harness. No pressure switch. Nothing fancy. Turn it on when you want air, and off when you don't.

 

That looks awesome. Where'd you get it ? Personally I don't think you need an emblem. It looks so clean

 

Nothing major so I just gave it a wax.

 

She looks sexy in between the cactus.

So how did the tires do?

 

It's a CustomCarGrill Grille. https://customcargrills.com/Custom-Toyota-Grills.asp

Got it from a member on here.

 

I bookmarked that same CustomCarGrill website a couple days ago with the intention of doing that too. Are you going to put the lower mesh in also?

Going to paint over the chrome bezel and match the MGM at the same time.

 

I have lightbsr that's going there. I need to cut out the lower valence. The only thing holding that up is my confidence in wiring it up.

 

Where did you find the molle type organization for the console lid?

 

Emperial guard I believe a whole higher class

 

Got my topper mounted light bar wired up. I used an add a fuse from the high beam fuse under the hood to a relay. Then ran the wires in a split loom all the way back and up the front of the topper. Not the most hidden way of running them but I wasn't ready to drill a hole in my topper just yet.



With the topper slid back.



Topper back in the installed position.



I may get one of these to help spread the light forward instead of down on the roof.

Nighttime pictures to come in about 2 months