Spc uca boot

Both sides tore apart and painted . Now to find someone to Switch springs to new pro comps and re assemble .

 

If I wasn't so anti people it would of been nice to have a helping hand on this job but I guess I'm a 1 man crew .

 

I believe that's a top out

You can source an axle. Run the stock gears and no locker. Run some leaf springs and do all the fab work yourself. It can be done under $3k.

 

See the posts I quoted above. He's obviously not going to run leafs on this hypothetical SAS.

 

No axle swap for me on this rig . Maybe later a set of fox coil overs and some new tires . Got this Banshee to build to play just need something 4x4 for these highway jobs that are usually a mud pit so if you don't have 4x4 at work you gotta walk a mile to the bridge .

 

And have a shitboxed sas Tacoma. This will happen when you wheel it also.

 

That's the last one I built actually. Everything I own is a shitbox nothing works I'm 13 lol

 

Sucks after all this shit got to order new boots for ucas might just go with another brand because I think I need new bushings too wtf .allways something rant over .

 

One side down one to go .

 

Very nice and clean. Makes me wanna do my hubs now lol

 

Both sides done just got to fill front diff got in a hurry and didn't jack each side up higher to prevent leakage .

 

Gotta get new dust covers I put a hurting on the ones I took out .

 

All back together did road test clunking noise gone when I hit any size hole but still got squeaking noise when I give it gas then if I let off gas it quits thinking maybe a u joint so basically I replaceda good set of wheel bearings but I guess I got a extra set .

 

And now for back shocks and a touch up spray can paint job .They did that spray on frame and every weld is rust again they should of replaced it .