1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Rear end question?!?

Discussion in '1st Gen. Tacomas (1995-2004)' started by Mis$I$sippi_hippie228, Aug 30, 2017.

  1. Aug 30, 2017 at 8:20 PM
    #1
    Mis$I$sippi_hippie228

    Mis$I$sippi_hippie228 [OP] Member

    Joined:
    Aug 22, 2017
    Member:
    #227710
    Messages:
    11
    Gender:
    Male
    First Name:
    Waylon
    The Gulf Coast
    Vehicle:
    99 taco, 98 taco, 03 taco, 98 taco, 95 4runner
    So I have a 99 3.4 Tacoma with a bad front diff and the rear needs bearings/seals. Anyway I found a front diff from a 4runner add and all same as mine but the guy Isn't sure of the gear ratio because the body has been scrapped. My question is will the third member out of the 4runner v6 non e lock fit it my tacoma housing v6 non e lock?? It would be cheaper just to put his axles/third member in my housing to match the front end rather than get new bearings pressed on my axles and I wouldn't have to fab spring perches. Any knowledge helps
     

Products Discussed in

To Top