6in lift with 35s

so I have a 2017 trd off road. I want to do 35s and a 6in lift but state laws say the bumper can't be higher than 28 inches. Will I be going over 28 inches or no? I have 30s right now and sitting about 20 inches off. Or would I have to do 4in and another question could I fit 35s on a 4in lift?

 

You can fit 35s on a 3" lift with enough cutting.

 

What state u live in?

 

28" from the ground? Is the measurement made to the bottom of the bumper? Couldn't essentially the frame mount be used as a measurement?

 

Are 35's a must? Its a lot more work than people think. Regearing is a must and that's about $1400. Not including install which is typically another $1000. I'll take a measurement tomorrow of my bumper and get back to you.

 

If you have a 2WD, you can do the 4" spindle lift and you should have no problems.

 

I can tell you that 35" will fit under a 4" lift if you want to cut and trim a lot of your truck. I will eventually be going to a 6" lift myself with 35". I can't wait actually. @iHoopAlot has already made this move and he has not had to regear or do anything else to his truck. Runs great. Only cutting I believe they did was the CMC. That's it. I do not believe he has plans to regear either. Plus if you plan on getting the OVT tune you may not need to regear either. Therefore, I think it's something you do and see what you think. You have options after the fact to do whatever you'd like. I'd reach out to @iHoopAlot and ask him for more details. I'm contemplating going 37" myself

 

Usually @smitty99 would chime in on this type of topic, but I think he was banned or something.

 

He won't be ground these parts for a month, for "constantly negativity towards 3rd gen" or something like that.

 

I have a 6inch Pro Comp lift with 35's. At the highest point on my rear bumper is just over 28 inches.

 

Lower air pressure.

 

and run bfg. They run smaller than actual size

 

Mine has stock gears and drives just fine. I mean yeah, on the interstate would probably be a better ride, but its not a necessity...

 

I have full skids, sliders, DOM steel bedrack and bumper w/winch. The weight has added up so that could be the case for me. I also live at higher elevation and mountains. Truck doesn't like hills.

 

Can we get a good side view of that rig. I want to fantasize about something I'm never going to do.

 

Here is @iHoopAlot before and after his 6" fabtech lift and 35"

 

Lol did he really get banned?

 

Heh, only cutting except you know.....chopping out an entire section of the frame.

 

He was. Tbh I'm surprised that went through. Seems to have made a lot of people happy though lol. 75+ likes.

https://www.tacomaworld.com/threads/banned-members-memorial-thread.115215/page-1864#post-16015569

 

Obviously with the drop bracket comes cutting the crossmember. Yes. I stand corrected. Thought that was a given with a 6" lift.