Colorado B.S. Thread

Guess what day it is?!?!?!

 

The day to avoid this thread and your shenanigans

 

Drive by thread raping day?

 

I can never win...........

Luckily i have found a place to do my bearings and most likely get it done under my 3rd party warranty. So if thats the case i think its a "win" or at least a wash.....

 

4/20 + 5?

 

Without my shenanigans this thread is useless. Without this thread, my shenanigans is useless.

 

I better leave before Steve-O reports me for the 10001 times

 

Peace Out Girl Scouts!

 

Give him this, wait I mean here you go @CO MTN Steve

 

So, no dealer program, per se, but there is an affiliate program I'm getting setup for. I'll have the link today/tomorrow. No savings, but if folks use the link, I can buy that rear bumper from Jake that much sooner.....Also might be able to work out some sort of perk for those who buy through the link.

 

Anyone else have this happen, brake never squeaked before plowing the rotor? My left front is toast from drive in today.

Side note, PHD scientist's are very intrigued when I pull my wheel off to check pad in work parking lot.

 

Mine did not do this, but when I randomly checked them one day there was almost nothing left and the sensor tabs never made a peep. It would have probably done the same as yours within another week or two, it was that far gone.

Edit: was the same side too and the passenger side had a bit more pad left

 

If you guys didn't get 150k out of your stock pads, you drive like assholes.

 

I'm from California so my right foot just had an on/off switch

I don't know what Steve's excuse is...

 

That's a disability, not an excuse.

 

I can't remember the last time I shot a deuce without my phone

 

Everytime time I camp. I can't balance a squat and look at my phone too.

 

Okay here is a legit question to all my metal heads.

If the description reads:Material: 1.50" x 0.06" Mild Steel Tubing - how likely is it for the tube to bend if someone backed into you in a parking lot? Is that a weak build of the tube?

Someone selling their light bar that could potentially go into Subaru

 

Been at work since 8/26...
Been working, living, sleeping out of my truck since the 12th