What Have You Done To Your 3rd Gen Today?

Did these fit seamlessly in the DRL/fog light housing? Just a swap of the bulbs?

 

Two things today.

Got tires and alignment And took off my rear OME shocks and replaced with Bilstein 4 inch longer ones.

 

Alfredo in San Diego. FCI metal works.

 

Got the light bar installed. What a PITA to install with the short screws provided. Still need to finish up the wiring. I want to make sure that the led bar turns off with the ignition so need to get an "add a fuse" to the wiring.

 

Which one did you go with?

 

Cali Raised combo beam LED bar.

 

Well I have the only 3rd Gen in my town but I noticed a 2nd one move into the next town. See how long it takes until a 3rd move in???lol

Thanks

 

Installed Roll-N-Lock bed cover with cargo management system, bed mat, and front and rear Husky Floor liners I got off Craigslist for $350 for everything.

 

Great buy!!!

 

Thanks man! It's turning out pretty well.

 

Hondo garage cell/cb mike mount, ditch lights, bumper led bar

 

Lmao that was worst part wastn it I dod mine today too i got so frustrated almost smashed the led bar. I also want to finish those last remote wires. What wire are you going to tap into to?

 

Shapeways plate and Ch4x4 switches? All looks good.

 

Thanks.

Shapeways plate yes that plate is awesome. The switches are from caliraisedled but i do have an arb compressor switch on order for that blank spot from ch4x4

 

Don’t be scared. Get a low amp draw led strip. Mine pulls like 1.3 amps. It has a positive and a negative wire. The negative can attach straight to negative battery post or to frame by the battery. Mine has a black cable coming off the negative battery post going to the frame like 2 inches away on inside of front right fender that I plan on using. The positive wire(usually red) can connect to the positive wire on the drivers side park light. There are two wires to the park light. One is a solid color and the other is a white with a black strip which I’m assuming is the ground since the left side parking lot also has a white with black strip and a different colored solid wire. I’m going to use a “suitcase” connector for that connection. You just rest the existing parking lot wire( the solid one) inside the connecter then insert the red wire to the led light. Then you close the top and it pushed a piece of metal into both wires forming them together. No splicing or cutting is needed.

 

Yeah they fit perfectly.

 

De-badged it.

So much better, to my eyes.

 

so...whats your initial impression ?

 

Got some stuff in the mail. Hope to get it installed next week.. I'll get pics up after.