What Have You Done To Your 2nd Gen Tacoma Today?

Mounted a 30" LED bar on the N-fab light bar, and found some late night mud to test it out.

 

Wired in some back 12-15 HVAC controls and tested my new head unit. Still need the 20pin to 28pin harness. What do you guys think about the orange and white lighting?

 

I knew I was getting close and looked thru all my daughter's stickers for a heart. No luck so I made this out of masking tape.

 

When i saw your picture i had to do a double take and was like I KNOW THAT PLACE!!! Dick's always hits the spot!

 

Hauled some stuff that stuck just a little bit out of the bed...

 

Little trucks can haul big stuff if you're...creative

 

Car wash lol

 

i like the set up looks great! the rims are sweeeeeeet

 

phenomenal images may just motivate me to get off my couch this morning. maybe.

 

Pick this up yesterday ready to install later today after work

 

Is that a bong on the left?

 

Installed OME 90000/886 coils to replace my 5100/884 combo to compensate for all the extra weight up front. Also replaced my stock uppers with these JBA UCAs.

Parts on order:

• @Mobtown Offroad High clearance rear bumper w/ swingout
• Optima Blue top group 31M battery
• @Pelfreybilt battery cage
• ARB twin compressor
• Slee ARB mounting bracket

'Tis the season!

 

Technically a sidecar.

 

Props for taking the time to do that

 

....That's what she said

 

Bed Risers

I noticed that the bed liner has these 4 "slots" if you will, molded into the the plastic near the wheel wells. I was't really sure what they are for, but I guessed that perhaps they are intended to be used as guides for inserting bed risers to haul sheet goods or whatever else might need to clear the wheel wells. So I made risers to fit.

I used untreated yellow pine 2x8's that I finished with several good coats of boiled linseed oil. The 2x8's are just a smidge too wide so I had to chamfer them down to fit.

I had the old cargo net from my Subaru (RIP) laying around, and I always found it to be very handy, so I wanted to find a way to incorporate it.
In the end two screws with big heads screwed half way in did the trick. Super easy.

Yeah! - Now I can haul sheet goods and shove stuff in my net to keep it from rolling around.

 

Did you get it to dim? Proves if it can be screwed up, I can do it.

 

Thanks!