Air fuel ratio on scan guage 2 HELP!

Can I show my tacomas air fuel ratio on my scan guage 2 if so how do I set it up? What about fuel pressure? Thanks

 

No sensor to monitor fuel pressure, so the gauge won't have anything to display.

 

Thanks! Good to know

 

its odd on that set up.no fuel pressure or oil pressure.

 

So it seems as though i will need to run additional gauges in order to monitor these two items.

 

Correct.

 

Ah another project. Ill have to do some searching on here for a right up unless someone can point me in the right direction. Thanks @Torspd for the info.

 

Their website shows the setups to get the A/F ratio:

https://www.scangauge.com/support/x-gauge-commands/standard-obdii/

07DF0124 & 07DF0128 show them.

 

URD sells a fuel rail tap so you can add a sensor for a fuel pressure gauge.

https://www.urdusa.com/urd-fuel-rail-tap/

Also- don't use the scangauge to monitor AF ratio. The refresh rate is garbage, and the read makes no sense 90% of the time.

I am an AEM UEGO fan, but Innovate gauges are wayyyy easier to datalog with, if that's your jam. Any exhaust shop should be able to weld a bung into your exhaust for the wideband sensor. When I had mine done it was like $35.

I think URD sells AEM stuff now too, but probably be able to find it cheaper elsewhere.

 

To bad Toyota does not monitor Oil pressure. You can tell so much by it if you pay attention to it.

 

I’m going to try that on my Tacoma and Land Cruiser, I kind of keep the SC2 in the LC to watch Trans and Coolant temps.

 

Here's what i used for the A/F set up (i believe)

Air to Fuel Ratio (True Air to Fuel ratio)
TXD: 07E02144
RXF: 04614544
RXD: 2808
MTH: 05BE00800000
NAM: A/F

 

Anyone have any recommendations for mounting options and or gauges? Seems as though the ol scan gauge is not going to do what i need it to do.

 

I’m a big fan of AEM’s digital gauges but I did have a hard time data logging with them. The innovate gauges are great for that.

The AEM gauges auto adjust for brightness, obviously all match each other, and are super easy to read.

I had the Lotek a-pillar pods in my 4Runner and really liked that setup. However, after driving my buddy’s truck with the gauges on the steering column, I kinda prefer that.

Here are a couple options:
https://www.urdusa.com/flexpod-gauge-mount-tacoma-2005-2015/

https://www.perrin.com/shop/interior-gauges/gauge-pod