Will This Setup Work?

https://www.customwheeloffset.com/b...oma&suspension=Suspension+Lift+3%22&drive=4WD

Doing it on a 3 inch Rough Country lift, I was also considering doing -12 offset rather than zero. It was meant for a 3rd gen and doesn't show up on the same website as working for the second gen.

Any thoughts?

 

Need a bolt pattern of 6x139.7​

 

Or, 6x5.5"; see Bolt Pattern 2

@R490
Hub bore is 108mm; Tacoma hub is 106.1mm.
You or may not need a hub ring depending on; lug style required(taper vs. flat) or, which side of the hub-centric vs lug-centric debate you fall in.

3rd gen backspace is 5"; 2nd gen is 5.25".
18x9 et -12mm is 4.5" backspace.
18x9 et 0 is 5" backspace.
So you should be good there.

Unknowns I'd be concerned about are; stud length/thread engagement with taper lugs and caliper clearance.

 

I see in you future.