Light Bar Install

MICTUNING 31.5" 180W Amber White LED Work Light Bar Combo Fog Lights with Customized Switch Wiring Harness Kit https://www.amazon.com/dp/B00WGHRFO4/ref=cm_sw_r_cp_api_183tAbF4BPZQV

I just bought this light bar to install behind my lower valence. The harness comes wired with a switch already attached that switches between the Amber and white lights. It’s a switch with two push buttons on it one turns the white on/off the other the Amber. Is there a single dash switch I could put in it’s place to do the same thing or would I have to wire up two separate dash switches.

 

Did you read the reviews?
One question seem to cover the switch question you had.
Also....never hurts to message the actual seller.
.

 

Yea I’ve read down through the questions a lot of them are about the switch. The dealer answered one saying you can’t swap it out others say it can be wired to two switches and one said he put it on a 3 position rocker switch. Does mictuning make a 3 position rocker switch that would fit the dash. One I could wire so the switch has two positions for the white and amber lights on and a third for off. I tried getting on mictunings site but it’s not cooperating on my phone

 

Oh ok.. i guess I was looking at this question.

Can i replace the switch included for 2 of these? http://www.amazon.com/mictuning-toyota-s… see more

Answer this question


A: Yes, I ran two separate switches, one for each color for my rzr. You just need to test the 2 red wire to find the colors. see less

 

Can anyone help me with this? I've got two toyota push switches I want to connect to this wiring harness in place of the original 2 button switch that is there. What am I wiring to what here I'm pretty new to all this wiring and haven't been able to find a resource to make much sense of it. The original switch has 4 wires coming out of it red, yellow, black, and white. I'm guessing red and yellow are the positive for the amber/white lights the black is ground what would the white be? Any advice on how to wire these switches to this harness. The original switch then connects to the rest of the harness which has 2 40 amp relays and a couple fuses on it and from there connects to the light. Any help would be appreciated and I can add more pictures if needed.

 

Check out this thread, has a lot of good info on light bars and installation

https://www.tacomaworld.com/threads...-you-might-think.406194/page-30#post-17256694