What Have You Done To Your 2nd Gen Tacoma Today?

Are you running a sub? If not I recommend replacing your front doors with 6x9 component speakers. I did what your doing doing and lost all the bass in my truck. I put these in the front door and it sounds great.

Infinity REF9620CX 6X9 750W Reference Series 2-Way Component System

https://www.amazon.com/gp/aw/d/B01E...zURCL&ref=plSrch#immersive-view_1515336812834

 

Is that the lightweight version of their rack or take premium rack?

 

Raleigh nc

 

I've got the standard rack which might weigh 45lbs but the premium one is too much heavier.

 

Just curious I'm looking for something to mount an RTT , shovel, axe, hilift, rotopax and awning too. Not sure if their lightweight rack would hold up. Also look at a brute force fab cage he makes since it attaches to the bed and frame

 

Voodoo rack can easily support all of that and a few people in the tent.

 

I'm just not sure how I feel about it being attached to the bed rails. Especially with the bed flexing when off-road.

 

Do you have a link to this event? Depending on when it is I may or may not be able to show up.

 

I decided to do a U bolt flip kit from RuffStuff offroad. There U-bolt flip kit is beast.
http://www.ruffstuffspecialties.com/catalog/UB325.html
http://www.ruffstuffspecialties.com/catalog/25TOY-UPLT.html
I already had some super bumps from @wheelers installed. Thanks to @Trident904and some fab work we installed this shit yesterday.

 

Too damn cold to do anything. But I did manage to vacuum it out and clean up the interior.

Also....got some potentially ugly weather moving in. Through on the DTs for a bit more bite.

 

so the air tube that hooks into the fender well was rattling like a mfer, so I decided I would give a cai a shot!! I may have gone about this a little differently than most. I didn't want to spend ~200$ on a kit just to find that my truck might not react well so... I bought a 22$ spectre cone filter, cut my stock intake tube to receive the filter, retro fit a gasket off of the stock air filter to make a gasket where the air box meets up. And voila, ghetto ass cai!! Now just need to make a box to go around the filter so not to get mud all over the filter!!

 

So how is the cone filter/intake arm leading to your engine supported?

 

I'm wondering where the cold air's coming from?

 

Installed mag lite on drivers seat.

 

Are those clamps drilled into the seat or stuck on?

 

Built my reverse light subharness then ran it from the rear to my engine bay, which I will say getting the wire above the fuel tank is a bitch!
Cut my exhaust in preparation for some relentless goodness
Then went to a buddies to put new g2 Terra grapplers in the rear and swap out my badly camber worn fronts, and threw one of his bent te37 18's on to see what I thought.
Also finally got my steering wheel lights working and put my axxess steering wheel connection kit in.

 

Currently resting on the power steering resivoir lol. I'm going to make it so that the box will bolt into the existing mounting location and will ultimately support everything

 

They are drilled.

 

I have the same size maglite inbetween the drivers seat and center console. It fits snug, does not roll or move in any direction and is tucked away neatly outta site.

 

Another job for the box I'm going to make. It will encase the existing hole in the fender well where all the cold air comes in. Also it will insulate the filter from the engine heat. Obviously it's not a true cai right now, but for 25$ all in including the material for the box I'm not really losing much in case I don't like it.