Norcal Spotted and BS Thread

Can I come do mine also? I just need to get a 3.5inch hole saw.

 

Walked into my favorite taqueria in Redwood City today. Every time I’m there I tell the chef how good his food is. Today I was 4th in line. He saw me in line and cane over to take my order. Then I sat down like a boss

 

No idea yet. If it helps you identify, its a manual transmission with a 22RE. 4WD. I'll see if I can get that info tomorrow

 

Me either. And if your under contract, your contract supercedes the law.

 

Possibly looking for a 4.88 as you can use them on 3rd gen 4runners. Cheap way to regear the rear and just have to figure out the front.

I’ll look into it, thanks.

 

Can’t help you there.

Lots of 4:10s floating around though.

I have an ifs v6 third member with the extra thick casting. 4:10s though.

I swapped out my 4cylinder third into the axle housing for an extra 3”s of width and bigger brakes.

 

Notice how it says should not shall.
This meaning its not required only suggested.
And if your bound by contract like all union workers are then it means nothing at all.
Even state workers are not subject to ca labor laws as we are under a union contract.
Is it bull shit ,yes, its a state law but the state dosnt follow it.
But if its a rule in writing and you signed it then there is nothing anyone Can do.

 

Dude super easy. Grap a sharpie. Line up by eyeball mark then make center mark drill hole.. if you fuck uo get some sheet metal lol

 

I’m using a 4”

 

I'm gonna buy a 3.5" hole saw to cut mine.

 

Sounds about right. For a 3.5 pipe. I used 3.5 for a 3"
I worried the 4"would be to low to the bottom of the crowl area and suck in water if there is any in there.
Why i went 3" thus giving just as much lip as the air intake to cab.
But many have done it and no complaints.

 

I gonna be using a 3.5 inch pipe. Now you have me wondering if I should use a 4 inch hole saw when I cut or use a 3.5 in hole saw and just trim it a little bigger after I add the molding around the hole.

 

Cool, well, I like to have all the inches I can get IYKWIM

 

I’m using a 4” pipe with it

 

You will be fine.
And depending on what your using for trim will depict how much you will need to over size the hole. 3.5 was a bit much for 3" pipe but it was what i had. And fuck it made it work. Silicone is your freind.

 

Speaking of daily drivers. I'm almost done rebuilding mine. Less miles on the truck is a good mod.

 

someone got some competition.

@Overlanerd @Iggy

https://www.youtube.com/watch?v=XTwAmh979oM

 

Looks neat. Seems like these habitrails need pop outs even more than the RV campers.