AZ BS Thread 4²0

Which connectors do you need?

 

The waterproof 2 pin deatsch (sp?) ones... if I remember right they have a green front, 2 holes, orange rubber gasket on 'em...

 

Weather pack?

 

that bubblegum still good?

 

Of course I can't find a shot down the barrel of it but I think that's not weatherpack??


This is what Vision X shows as their harness. I bought them a while back w/no harness.

 

If you're willing to cut those off I have weather packs and the right crimpers.

 

The pigtails are already on the short side... but there's no reason we couldn't extend them a little longer, which would actually make life easier. I reckon I'd be down for that.

 

Up to you.
How long are the pigtails attached to the lights?

 

I thought those were the CL ones
Dudes selling 5 37s MTRs ranging from 50%-25% tread left for 200

 

I smoked some bubble gum just a little bit ago... Very nice indica! Be safe. Cracked this bad boy open last night... Hmmmm... Its not gonna last the weekend.

@fluffer... You could be involved in all 3 tasty morsels

 

They tuck into the weather strip nicely but they stop right at where the hood hinge is, basically. Total PITA especially on the pass side where you need to have clearance for the washer hose too. Will probably have to look at exactly what the best way to route them is (and the best length for that) once I actually have the switchpros going in.

 

When I bought my Cali raised, I bought the Caliraised switch as well and my connectors didn't match. I ended up just cutting everything off and using Delphi weatherpacks. Got all the pieces from Del city

 

The Vision X connector, if you had it, may not fit on the pass side.

 

You sir are an OG

 

Thank you sir... Progress is being made.

Anyone wanna come over and investigate?

 

Damn Ryan. You've been busy today.

It was great to finally meet you two.

 

One last Hara before you kick them all out?

 

Making a portable jungle gym to get Daria training for gymnastics?