What Have You Done To Your 2nd Gen Tacoma Today?

This is an ARE windoor. I'm confused if you are saying they're the same.

 

Cool they changed them up them they use to be the same as yours, the ones I have seen at least.

 

You'll love it more if it's on your armor bumper. That' what I did

 

Gotcha, all I can figure is that it's just to differentiate their brand from the others.

 

Looks good!! I love my vented windoors as well.

 

They grow up so fast... This happened on the way home tonight from pick up soccer.

 

Just finished mounting the catch can and plumbed it. Thought it came out pretty well and as expected but the only thing I didn’t account for was the angle of the inside fender wall. Notice that the bracket angles upward. I’ll be fabricating a new bracket that compensates for that angle. I also had to use some pieces of rubber hose to prevent chafing of surrounding hoses by the stainless braided lines.

 

Looks great

 

Used it to haul home a 14 foot stick of 2x2x.120 steel square tubing. Fit perfectly through the basket and attached to it with 2 ratchet straps.

 

I kind of like the no center cap look!

 

Just finished my TRD pro coilover upgrade. Got the whole set, front and back shipped fro rogue for $700. I will say passenger side is WAY easier, so start there first. Gained 2” on passenger and 2 1/2 on driver, now I’m at 37 1/2 for both sides up front. I’m waiting on my rear leafs from Toyota to come so I can get the recall done. I’m nose high about an 1”. Hopefully I’ll gain that back with new leafs and the new shocks.

 

Used my skid plates today

And I pressed all the buttons

 

Damn tough spot

 

Not really. Locker came on just to test the actuator since it's been a few months. Atrac and dsc were on because I was effing around.

 

WHERE DID YOU GET THIS GRILLE?

 

Finally got around to fixing the shunt resistors (again).

 

I wonder if its an Ebay one with emblems?

 

Added some sweet cup holder inserts thanks to @CookieMonster

 

very nice job!!!! I have been playing with ways to drain mine, valve to 90* fitting on the bottom...looked at hose etc...figured out today the simple st thing...put a large baggie around the el..let it hang down under and drain it in the baggie KISS dummy