4wd conversion dashlights

Hello all, I have a question about using the factory 4wd dash lights. I am half way done with my 2006 Prerunner to 4wd conversion and the have the front carrier installed and im using the RST harness for the actuator. I want to use the factory 4wd dash lights in the cluster to show activation of the 4wd but I am not sure where to find these wires so that i can hook them up to the sensors on the FJ manual xfer case. I've searched on here but cant seem to find anything. I thought about using separate LED's but I'd rather use the dash lights if possible. Has anyone that has done a Prerunner/4wd conversion got this to work? I tried contacting Wyatt at RST since he told me he's done it before but haven't received a response yet. Any help is greatly appreciated.

 

I'm doing the same thing with my truck at the moment...
This write-up may be what you're looking for to wire up the sensors...


https://www.rocksolidtoys.com/single-post/2017/08/25/05-Tacoma-IFS-T-case-swap-wiring-instructions

 

Thanks for the reply and the link. I did see that before but since I have a Prerunner I don't have the 4wd ecu connectors behind the dash. I was hoping someone knew about how to wire it up on the Prerunner.

 

Ah ok. I have the pre-runner too and I think I saw a thread mentioning which wires go to what behind the dash.. let me see if I bookmarked it.

 

https://www.tacomaworld.com/threads/prerunner-to-4x4-conversion.534480/


This page, post #9, shows which wires in the various connectors connect to 4hi and 4lo. His truck was a prerunnner and had those connectors...

 

Awesome! That's exactly what I was looking for. You rock!

 

I looked behind the glove box for that f12 connector like the link says but couldn't find it. I'm assuming the f12 connector is one of the ones for the 4wd ecu??