BAMF IFS skids

Man I fucking hope so. That's what I run also.

 

You might have to sand the X brace down a little there is a lot of room above the mid skid but if it hangs down you might have some contact with the skid. If you want to check you need 2" of clearance from the bottom of the trans cross member up so if it's more then 2" higher your good if not there will be some trimming to do or we leave the X brace off.

 

Are these ready to ship?

 

Not quite we need to make crossmembers for the Trans skid is all we ran out of 1.5x.250 wall square tube. We got a few orders all of those should be shipping later this week.

 

@JLee new skid set looks great! Do you have any plans for a gas tank skid I'd like to get everything at once and save on shipping. Still waiting for more people to do diff skid GB think we have 5/20 last I checked.

 

At the moment there are no plans for a tank skid

 

I can confirm that the Transmission skid does NOT work with the URD Y-Pipe. Not even close. Just got my exhaust re-worked again today to fit these skids. Now to find time to get them mounted and drill the holes through my frame and sliders for the Transfer Case crossmember.

 

Anyone have any idea if the skid will fit 2016 taco ?

 

hey @JLee looks like i'be misplaced some of the bolts. could you post a list of hardware for each of the skids on the front page so i can get some replacements from the hardware store?

 

@JLee Do you know what an estimated wait time would be for an IFS skid? Time for me to get this cheap tin stock one off the truck

 

We're a few weeks out on the next batch right now.

 

Is there a currently a list? Who am I kidding, I'm going to order one tonight regardless

 

Might as well just order the whole skid set

 

Send me an extra 500$ and we go ourselves a deal!

 

Just start in the front and work your way back. Install is pretty easy, everything will line up no prob. I would invest in some good bits for the last skid. Step bits will work good once you have a small pilot hole already drilled.

 

We are working on Install instructions i don't have the pictures i need to finish them. but they are very easy to install. Everything lines up with factory mounting locations but the trans cross-member that's where you need to drill.

 

They are to long we had a box of miss labeled bolts that were an inch too long.

 

URD Y pipe does not fit

 

Advise *** Make exhaust adjustments at your discretion. This may not be the correct way to route but this is how I managed to do it at home with URD Y pipe.
I cut 1.25" from the verticle section on driver side below the o2 bung. Score pipe before cutting and keep orientation the same. Undo passenger side exhaust clamp to allow section to realign roll and I also had to drive those 2 sections in tighter to keep her in same place. Only had to cut 0.5" from X brace to achieve adequate clearances.

I now have 0.5" clearance to driveshaft and 1.5" from trans.

 

Beat the living daylights out of mine this past weekend up in Big Bear