Fixed..... Errors after new tire mount, balance and alignment

system is saying BRAKE lit up, brake override malfunction AND Smart entry & start system check , yellow warning triangle flashing. Says see dealer for service. Seems to run and drive fine except when coming to a stop it seems to stumble a little. My remote start starts the truck then immediately turns back off. Tried to remove black battery terminal for 5+ minuets and nothing. Anyone got any advice before I goto dealer tomorrow??

 

Did you do the work yourself? Or have a shop do it? Possible ABS issue?

 

ABS cable damage??

 

Mavis tire took them 3 hours to get done and I left there drove for two miles see if it went off and it didn’t so I went back. They put it on the lift to check everything all brake lines and wires to abs seemed to be intact. Owners manual says it’s from hitting break and gas at same time or something but I’ve power breaked the truck long ago with stock tires and never saw this before

 

Stretched ABS wire...

 

What’s a fix new wire? Any way to reset or even check to see if that’s prob for sure?

 

Most likely need to be replaced.

Go to all 4 corners of the truck and check out the wire coming from the back of the knuckles, if any of them are ripped or stretched out. That’ll be the culprit

 

I’ll have to check in am. Why would that mess with my remote start tho?

 

Not too sure about that. Maybe the car doesn’t think it’s in park or something along those lines ?

Maybe someone else can chime in with a suggestion

 

Hopefully have some answers tm

Either from some one else here or dealer when I call tm

 

Here’s a better pic of the screens

 

If you could use an OBDII scanner with ABS capabilities (like the Actron CP9660), it might give insight into which ABS circuit is failing.

 

idk just dropped it off at dealer seee what they say

 

dealer things it the remote start they had installed, waiting on the tech from outside company that did it to go on over and check it over

 

Fixed it. Alarm was wired crappy created a short and blew a fuse. New fuse in and alarm re wired and I’m good to go