AZ BS Thread 4²0

Or did you travel to the future and see my post then come back thinking it was a repost?

But yah don’t go back and quote the original post, I believe you, I just couldn’t remember if I saw it here or else where, so what evs.

 

Bill the butcher is a bamf

tell you friend’s daughter happy sweet 16 for us....

 

It’s @PangTRD’s birthday?!

 

That was what he wanted. I didn't know he went vegan.

 

Driving home today in the runner, start hearing what sounds like a formation of helicopters getting ready to land on top of me. Nope...just a ‘97 stock driver side wheel bearing going out.

I’ll give her pass for 20+ years and 165k miles of island service to finally blow a wheel bearing.

Best source buy a bearing and hub assembly pre-pressed? Asking for a friend

 

You can really lay some pipe.

 

I see you’ve been taking the photography school of @Brian007Taco while on the island.

 

So, some of these jokes are getting old and very inside. But I still giggled when I read it.

 

The GI Bill only covers so much.

I kinda like the sun filter with both ‘yotas and the American flag.

Too bad you can’t see my caramel light cream double shot machaito frapachino and the duck lips I was pushing in this photo.

 

Btw it’s only 79 degrees here today...how’s 99+ in May treating y’all?

 

Meh. It’s kinda nice. Means the wife likes to skinny dip then chill

 

Just finished putting together the desk. Went out and bought a new one just cause I got a good deal.

 

Skipping Netflix and going straight to chill is the best

 

Need to go speak to my boss's boss's boss about how much my boss is a horrible boss in the morning. Anyone hiring an accountant, asking for a possibly soon to be fired me.

After typing so many bosses I can't even tell if I spelled irlt correctly.

 

@RPS1030 is there a reason @JerryTaco used an air hammer over a cut off wheel do remove the factory bump stops?

 

Frame rivets are a bit grumpy. We used a plasma to melt the head off and then I used the flappy disk to grind the residue down to the frame. Once that happend a very quick blast from the air hammer shot the rest of the rivet out, nice and clean.

I would post a picture, but sadly I lost them on the phone. Theres probably some in the build if you want to dig. It, I assume all that makes sense.


Yes, the dirty lightsaber was probably overkill, but I really wanted to use it.

 

So cut off wheel only is prob not going to get the job done?