What have you done to your Tacoma today? 1st Gen Edition

lol I think all Tyler heard was "DO IT!"

 

I'll put it this way.

If you want to. Go for. but you NEED to practice welling a lot more. You'll want smaller wire for the body shit. And i'd practice on you shitty truck before trying to ruin your nice truck. That is not a fun first welding project at all. And going off your last photo of a welded wrench..you have ways to go..

 

Yea... wide lol

Getting closer by the day!

 

man your ride height looks tall..

 

For guys with the manual / non-ADD front diff axle shaft / tube, what part number do you have for the passenger side oil seal? Dealer gave me

$11 90311-47013 Toyota Genuine Oil Seal for Differential Side Gear Shaft

90311-47013, but that's showing as a 2nd gen seal.

 

True, 35s + LT/4-Link + 1" poly body bushings + fiberglass gives it a pretty high stance, lots of clearance. New bumper also knocked several inches off the old tow hitch.

The extra width and sway bar keep her stable on the mountain roads however.

Still maybe eyeing a gofast camper style in the future.

 

nah even your front kit looks like it is a bit high in general looking at the LCA angle.

GFC would fit your build way better then having a rtt up that high. Certainly would allow you to open up the taps more in the dirt!

 

Good advice.

My other option was cut the rusted parts out of the bed and weld in patches, but changing out the bedsides seemed simpler.

 

Was stink bug before, pretty sure the rear bumper leveled her out some, shifting more weight to the back, also swapped out to synthetic line. Sure that brought up the front a bit too.

 

Gunny quoted me

$11 90311-47013 Toyota Genuine Oil Seal for Differential Side Gear Shaft

90311-47013, and that’s what I used on the passenger side of the manual hub axle tube.

 

And

$10 90311-47027 Toyota Oil Seal - 90311-47027

90311-47027 for the ds?

Man I miss Gary lol

 

47027 yes.

Gary is still here, lol. I just ordered a seatbelt from him last night. He’s working through DM’s only now it appears.

 

Man he passed me up when I DM'd him a week ago Nothing big - can't even remember what it was for. I'll keep being the squeaky wheel though!

How much for the seatbelt?

 

I paid $150, I think the one with the explosive pretensioners are more expensive.

I use the same convo I’ve had with him for over a year. It doesn’t get lost because I have a message history with him.

 

I weld semi professionally and I would pass on body work. Its like when you catch a piece of paper on fire, the hole just gets bigger, and bigger, and well you get the point. It would be a waste of time and money. Why dont you spend your money on getting that lift installed?

 

How long will it take for me to swap the tensionor bearing?

 

Oh I can install the lift myself, it’s not that difficult. I just have to have the fronts rebuilt.

Guess I’ll hunt for a new bed.

 

Better option, especially since you are in Cali, land of the rust free!

 

Yup.

 

depending on the holes and location. Yes that is a great option and easier then doing the whole bedsides.

gotcha. Id check where you are sitting in terms of up/down travel and try and get it as close in the middle as you can. Really makes a difference.