SCS F5 -38

I did a search and didn’t see anything (granted I’m on my phone). Is anyone running the SCS F5 -38 setup? I’m curious how the poke is and how much cutting was needed.

Thanks

 

There’s lots of goodies here, but you’ll have sift through who has what. @ChadsPride might be able to help

And while you’re at it, have you checked out TTC?

 

https://www.instagram.com/p/BWyIzANAqs_/?utm_source=ig_share_sheet&igshid=4fkpxrgke84e

She runs -38mm on a third gen. Not sure if she’s on TW, but you can see and read all she’s done to make them work.

And..

https://www.tacomaworld.com/threads...-f5-photo-thread.502639/page-41#post-18195120

There’s a thread in SCS’s vendor page too.

 

Sup Gary!!!
​

The amount of trimming will widely vary depending on your lift and tire size.

Mine is somewhat of a special deal becuase the aftermarket spindles push the front wheels out .75" per side

That being said, I did the cab mount chop in prep for the 285s. And when mounted all I had to do was trim some of the bottom inside plastic on the front fender flares.




Like @Beef Nachos said, you can see more pics here

https://www.tacomaworld.com/threads/stealth-custom-series-f5-photo-thread.502639/

https://www.tacomaworld.com/threads/scs-f5-wheels-16x8-17x8-5-17x9.230532/

 

Definitely need moar pics of this. Its a shame that there does not seem to be a lot of selection for these specs.

 

Thanks for the replies. I’ll def check her out on IG.

 

Just put my name on the list for -38 Ray 10s. Gotta wait a few months to do the lift anyway.

 

Very cool!!! Can't wait to see those

 

Same. I have the money set aside in my PayPal ready to for @SCSPerformance @scs_vuth

 

​