What Have You Done To Your 2nd Gen Tacoma Today?

Man, I love that green.

 

Worked on a switch panel to replace the 4-switch/2-12V socket area with 7 switches
The light's getting bad, sprry about the focus. I'll try and get a better shot after the next phase.

 

Where u putting it at in the truck

 

Just under the AC controls where the existing 4 switches are.

 

How does that mount? Cool.

 

Can you reuse the hood or it’s different?

 

That my friend is a sharp truck. Sweeeeeeet

 

https://www.tacomaworld.com/threads/2012-tacoma-front-end-conversion-rg11.293318/

 

How much $$$$$$$$$$$$$$$$ ?

 

I'm still confused- OP talks about exchanging the hood but post #3 shows pics with scooped and non-scooped hoods. He purchased two hoods?

 

Essentially look at his parts list and go off that first post. The hood is different yes and yes he started with the non Sport hood then upgraded to the sport hood.

 

Finally took the ‘TRD Sport’ stickers off the sides of the bed. I’m loving how clean it looks now

 

Nice. I did the same but up top. Made two harness just so it was easier on me to put through and if I had and problems

 

Ok he did replace the hood twice, thanks

 

You now drive a SR5

 

You right

 

If I end up needing switches up there I think I'll hide them in the front holder so they pivot down to be used but are normally hidden. I still have 5 spots available to the left of the steering wheel because base model. Savings those for lighting. So far I've added one rocker to the door armrest for cab/cap slider control and 4 oba switches, regulator, and guages to the center cubby and now this panel which gets 2 seat heater switches, 2 camera switches, the aux/usb port, and a dual usb power port/12V display with 1 leftover. Not sure yet where I'll relocate the 12V sockets, maybe 1 back face of the center console for fridge, certainly 1 in the bed probably with an inverter next to it.

 

I just used 3 short course threaded screws. If you wanted to remove panel you could bolt. Since I plan on very little if any use (fingers crossed) it should hold fine... pretty sturdy.

 

3" Toytec and SBC UCA's. 18" Fuels and Nittos.