Wheel or tire issue ?

Does anybody had this issue before ?
I put on 17’ TRD wheels with
falken wildpeak at3w 265/70r17 and the wheels and tires on the right side are like an half of inch out of the fenders than the wheels and tires on the left side of the truck ......
When you look at it from close range it’s really obvious and don’t know what it cause is it ....
I’m not sure from those two photos you guys can see it properly but it’s there ....
Anyone ???

 

Does the bed line up with the cab ok?

Its neither wheels or tires. Its either a crooked bed or off center axle.

You just didnt notice it before. Several folks have had similar, both are easy fixes.

 

It does ..... it’s a 5k new Taco ...

 

The funny part is that both wheels on the right side wider than the wheels on the driver side

 

Doesnt matter. Edited my original post for more info.

Swap sides with wheels tires and i bet the problem wont move, meaning its the truck

 

Been discussed. Alot of people have the same complaint. Mine does it too but its not hurting anything and i just stopped looking at it. If its under warranty, take it to the dealership.

 

Great Quality control

 

Built that way by the factory to keep driveshaft /U joints angles to within spec ........

 

It was only 5k so maybe they cut corners during the build.

 

I got it brand new and put on it 5k

 

You need to take more sharp lefts.

At speed.

 

That’s to deflect you from noticing the Taco lean....

 

Looks fine to me. Maybe you are not standing the same on both sides and it's just the angle your at?

 

The photos are not that good , but took it to my buddy body shop and he looked it and said that one side is out more that the other .....

 

As mentioned it is so the driveline angle stays at a certain amount of degree to keep the u- joints alive

 

As mentioned earlier....is your bed squared up with the frame/cab??? Seems to be a common issue that beds are not installed correctly frequently (among other frequent issues).

 

Are you lifted or stock?

 

Parallax