CSF All Aluminum Performance Radiator For our trucks FINALLY!!!

The picture in the instructions can lead to that mistake. See it before as well. Almost like an optical illusion .

 

Thanks for getting this started.

 

You betcha!

 

Mine has a slight hesitation from cruising to WOT as well. Doesn’t do it all the time, but it’s noticeable when it happens. I think it’s UCON/tune related.

 

Just so I got this right.....I bought my coolant today based on what the first page stated was the amount the CSF held, 120oz. So I bought 1gallon as that will get me just over the 120oz. My question is.....that’s roughly all I’ll need? I thought I’d be dumping a little more than that into it....

 

I want to say I used 1.5 gallons ish when I installed mine. Don’t forget you will loose coolant from the hoses and what not

 

When you disconnect the hoses, you’ll drain more than just what’s in the radiator. But if you have the ability to catch most of what drains out of the existing fluid, your gallon of new coolant will be more than enough.

 

And/or if your coolant has been in the truck for a few years it's a good time for a refresh. Just drain out as much as possible and have 2 gallons ready. Then you know your fresh!
Everybody like fresh!

 

Yes my plan was to drain it all out (minus the s/c) and replenish with new. So 2 gallons should do it then....good to know. Back to the store I go!

 

I used 1.5 gallons.

 

Copy that

 

Radiator finally going in!!!!!

 

Oh......and my 70mm throttle body. Thanks again @mach1man001

 

No problem

 

Have any of you guys run an AEM temp gauge into your radiator? If so how did you connect your electronic sensor? Into the drain plug?

 

Don't that also make an inline adapter, for the radiator hose?

 

You want something like this to mount the sensor into. You splice it into your radiator hose. You want it in the hose that feeds coolant out of the engine and into the radiator, so you know how hot the engine is running.

$7 VGEBY Car Aluminum Water Temp Temperature Joint Pipe Sensor Gauge Radiator Hose Adapter Clamps 26-40MM (Size : 32MM) Radiator Hose Adapter 32Mm Water Temp Sensor Adapter Glowadapter

https://www.amazon.com/dp/B06XRVNYQ8/ref=psdc_15730681_t2_B00FY2TCZ8

 

Yeah, I’ve been looking. I wasn’t able to finish the install on my temp gauge because of that today. I’m on the hunt for a 1.75” sensor adaptor. They seem rather hard to come by....

 

This is the one I used. 36mm version.

$10 Dewhel Aluminum Black Water Temp Meter Temperature Gauge Joint Pipe Radiator Sensor Adaptor Clamps 36mm

https://www.amazon.com/dp/B018FY10PQ/