Inesshell bs and lazy af build

I told him red or black. Silver might attract too much brake dust, and be hard to clean

 

Front?

if you drill to far forward you lose output since the front well backing will cover half of your output

 

The front, aka under the battery. I dont know the name, but @Arcticelf does. He is building me a bolt in replacement

 

could also mount it behind your bumper and aim it back a bit, bend some sheet metal to make it work. one of my buddies did this when he did his bd rock kit, they come with mounting brackets for that kind of thing tho

 

4x4 illumination switch mod

Things needed,

@rcbs204 4x4 led panel -- https://www.tacomaworld.com/threads/rcbs204-4x4-illuminated-switch.68173/
screwdriver
soder
knife
patience



remove all tech deck stuff to get to ac panel



use a knife to remove panels and disconnect 4x4 switch harness



slide bottom bracket from the 4 pins holding the backing in

- remove slowly not to pull the switch assembly, detents could go flying




remove the brown cap for later running the wiring and sodering to the board



screw the led in place to the faceplate and run the wiring through the earlier board contact plate



trim just enough of the board to allow sodering of the wires to the exposed contacts
- soder the white contacts closest to the harness plug and the red one the furthest away



using the extra supplied wire, slide the terminal ends into the black 4x4 harness, the red one next to the white wire and the white one on the end as shown




route the wiring behind the deck plate and through to the ac panel compartment

- expose the ends of the wiring for the next step



i didnt soder for this step, i simply slid the exposed wiring into the terminal end in the plug harness

- red goes into the green and white wire
- white goes into the green wire just behind it

testing


assemble, test, and test 4x4 modes




new swingout table light

 

I have had that thing during around since the last group buy guess I need to get it out in. Looks good man. Love the lighted look

 

lol, one of the few mods i say are worth the price

 

Mmm truck saw arrived, gassed up and tested if chain gets good flow of oil

 

Just saw you'll change your front bumper. It's the end of a chapter... if we were closer I'd get it from you with your autograph! My truck would be a legend with @inesshell 's bumper on it!

 

sure man lol, it wont be for a while -- everyone's lead time is outrageous right now

 

Got it on order?

 

waiting for bf, but i have specs and measurements all discussed with him leadtimes times right now are killer tho.

 

Pay in full
​

Also, you know it's worth the wait! But I do understand.

 

pay in full speed it up ? .... ill ask

 

No asky, just doee. ​

 

Mine still took like 14 weeks IIRC

then I felt bad because it collected dust for about the same amount of time

​

 

took me a year to do rear lines because i rounded one....and took me forever to find a tool to hammer on to remedy it

 

For reals... I dont know how many times I had to post "".

 

now we must @ChadsPride for a hc