Bilstein setup 2016 Tacoma

Hey yall,

New to the whole mod world and trying to figure out my best route. I've read a lot about the 5100 with OME coils and aal in rear but wanna confirm with exactly what I plan on using. I was gonna run 5100 struts (need help on which notch to set) with eibach coils in the front and a toytec aal in the rear. Trying to get a 3/1 from the results. Can anyone help me on whether or not this will do the trick or where should I change?

 

You want the front 1” higher than the rear? Remember that 3rd gens are already 1” higher in front than 2nd gens.

Send an email to Marie @HeadStrong Off-Road next week. Explain what you want to accomplish and your budget.

 

I am not sure about the spring rates of eibach. Going to need to figure that out. If you go with a ome coil then you will set the perch on the shock (not strut) on 0, the lowest setting.

 

I don't want it 1" higher in the front I want it leveled out after everything is finished. 1.5-2" aal and shocks in rear should do this if I set perch to 0?