Quick help on Clazzio install?

Hey all, I’ve got all the covers on except the center console cover. Instructions are not clear at all. How the hell do I put this on here? Start with the latch end or the hinge end? Do I have to take the console cover off with a screwdriver or something?

 

Yea no. I said to hell with that. Wasn’t worth the effort

 

2nd gens have a plastic insert on the underside of the lid held in by tiny phillips screws that was required to remove and replace to install. Removed plastic piece, wrap cover over top of center console. I used pieces of duct tape to hold cover as tight as possible while putting the plastic insert back on. Problem I had was screwing the plastic back in after the leather was there since it covered some of the screw holes. I used something sharp to poke holes for the tiny screws to go though. It turned out ok enough for my ocd to not tell me to rip it out and throw it in the garbage, but was definately close to that.

As well as the rest of the covers are designed, this center console cover could have been designed better imo. I think alot of people just run without it. Still one of my favorite mods to date.

Hope this helps, I dont own a 3rd gen.

 

You don't have to remove anything. Latch portion on first. Then just pull over the back and then velcro underneath. Makes it easier if you tilt front seat all the way back. Just removed mine and put back on on less than a minute to make sure.

 

I installed my Wet Okole’s this morning so I’m sure it’s similar.


Move both front seats all the way forward and lean them up. Start with the front and pull on each side to get them back. I used one of the automotive trim tools that was flat to then push it down between the cup holder.



Or I believe you can unscrew it, install, then put back on.

 

Well no idea. But on the bright side the seats in the background look good!

 

Latch side first. It’s a bear but it’ll go.

 

Would love to see pictures of your seat covers. I am hoping to order mine before the end of the year.

 

Sure. Give me a few.

 

I didn't bother with the center console cover.It would not look good enough for me .

 

Sorry for thread jacking OP, I doubt you were looking for camo but these are the same pattern I had in my Ram and they still looked brand new after 50k miles so I went that route again.

 

Thanks allot my friend. Those fit very nice,I will definitely be ordering some Wet Okle for my Tacoma. I should be picking it up next week, finally decided to let my 2007 go for a new one.

 

Very nice!!!

 

No console cover I see. You get it OP?

 

Gave up for now. Hanging Christmas lights outside trying to beat this blizzard that’s about to hit. I’ll mess with it tomorrow again.

 

No issues for me. Heating up cover might help.