What Have You Done To Your 3rd Gen Today?

Installed some nitto ridge grapplers 285/75/16’s on my factory trd off-road wheels. NOTE they do rub a smidge on the upper control arms with a 3” old man emu lift at full lock.
If the wheel is turned 99% it doesn’t rub, that little extra .99 it starts to rub. I also have a set of trd pro wheels 17” with 285’s on ko2s and they do not rub what so ever. I have a full break down of the lift and tires on a separate post however just wanted to share my 285/16 results as I just got them. Hope this helps anyone whos looking into the same setup

 

Sorry for your loss brother, just wanted to send my love from a fellow dog lover

 

Scumbags. Sorry man

 

Man that just sucks! You make it sound like you knew it was going to happen are you in that bad an area? I know thieves can strike anywhere! Glad you were prepared anti theft deterrents did there job!

 

cant miss it.
pull the cluster while its beeping if your not sure.
once cluster is unplugged and on workbench you will need a small torx driver to remove rear cover.
give the small round black beeper a good hard twist an it will pop right off the circuit board.

 

Are these correct pix. Found in another thread.

 

Good looking tires @Thewhite_emu

My Cooper STT Pros arrive tomorrow

 

Yep thats it.
Whole job shouldnt take more than 10-15 minutes

 

Any links for this process, very interested. I’ve never had a vehicle beep so much at me lol.

Also, if you have a trailer hitched and truck in reverse it beeps beeps like you’re running into something. Is there a way around this?

@Dragracer_Art

 

You might have park assist on. When backing with the trailer, thinks you are to close to something that you might hit. Just turn it off.

 

Not sure about the backup sensors... as my truck is not equipped with them.

The cluster beeper is stupid simple to access.
Be sure steering column is tilted down and telescoped out to give you more room to work.
Just pull on the dash trim. It pops right off.
There are 4 10mm/phillips screws holding the cluster in place.
pull the cluster out to reach the two plugs. press small tab in center of each plug to release them.
put cluster on a soft non scratch surface and remove the torx screws around the back cover.
After screws are out, use a pick to release approx 3 snap tabs and it pops right off.
Grab beeper with pliers and twist it off the circuit board.
Done.

 

Which way turns park assist off

 

I believe you just turn off park assist as mentioned.

 

Much obliged

 

I'm in the Jackson area too. I've wondered if there was anyone else on here. We should try to schedule a mini-meet.

 

Alright, button right by ECT! I like the park assist until I’m backing the trailer in! Lol it’ll beep beep beep you lol

Many thanks @20tacoma17

 

None at all, I'm good to go.

 

Cool. There’s some from the coast on here, and a handful of others. I think one of the MC students/faculty is on here. Usually post pics of snow and what not.

The Mississippi thread has a post every few months lol. Crickets on there lol

 

Got the Prinsu mounted up. Got dark on me so I’ll get the CaliRaisedLED lightbar mounted tomorrow

 

Snug top and decked system.