What Have You Done To Your 3rd Gen Today?

But I already have all my switches I just need to clean up rats nest of wires under the hood and get one hot wire on the battery instead of 6

 

zoom in on the right side...total mess

 

Unless you make a harness out of the wiring going to the switches and relays, it's going to be a rat's nest.

 

Well crap

 

If that's all it is, you just need a fuse block.

 

$41 Blue Sea Systems 5026 ST Blade Fuse Block 12 Circuit with Ground and Cover

https://www.amazon.com/dp/B001P6FTHC

 

But, that won't eliminate all of the relays that you have.

 

That’s it...no circuit breaker or any of the other things I see on peoples power trays

 

Relays I can deal with

 

Would you suggest a tray for that or just mount on the fuse box cover?

 

No need for a breaker since all of the circuits will be fused.

 

Came here to say this. You could either go with an all-in-one solution like the SwitchPro or SPOD, or you use the switches you already have with a DIY fuse+relay box of some kind. Here's an example of one I found on the net for ya:


You then simply figure out a way to mount that under the hood and you're done.

Good luck!

 

Yea, you have at least 4 power supplies going to the battery I can see. Definitely need something. Until then it's amazing what some cheap wiring loom can do to clean it up a little.

 

Ty

 

That's your call.

 

Well good sir...I must say you have opened my eyes up to this whole thing. Thank you and others for the input...def gonna look into this...y’all are the best

 

Took it off road and got it dirty

 

I plan on doing the dump and a reroute for skids. Also gonna see about getting my oem chrome tip on the exhaust where I cut it.

 

Installed some AVS in-channel rain deflectors and slapped some black lettering on the tailgate.

 

Installed Baja Designs S2 Sports Wide Cornering (flush mount). Followed existing wiring harness, along the frame to the engine bay. Connected to Switch Pro-9100.