FS: RCI Bolt-on Sliders

I bought these sliders in April 2016 and really like them. They haven't seen any trail damage - no scrapes or dents - just some rock chips on the bottom of the powdercoat.

They are made by RCI Metalworks in Fort Collins, CO and will run about $825 new. They will fit 2nd Gen (and maybe 3rd Gen according to RCI installation instructions), double cab short bed or access cab. They came powdercoated from RCI and are the standard 20 degree angle. I'll include all the hardware I pulled off.

I'm only replacing them because I bought a new set from RCI, this time with top tread plates and 5 degree angle.

Asking $500, local pickup/meetup only. I'm in Lafayette, CO off 287 but I make fairly regular trips to South Denver, Boulder, and Summit County. Shoot me a PM and we'll figure something out.



Overall powdercoat is in great shape, except for a couple spots.


Rock chips from my too-big-for-my-own-good tires.


The worst spot - driver's side, probably caused by rock chips. I didn't notice it until I pulled the sliders them off. I think it could be patched with Plasti-Dip but I didn't want to cover it up before selling.


And they look great on the truck.

 

If you feel like driving thru Wyoming, I am in Bozeman and would buy these in a heartbeat!

 

God dammit all these good deals popping up when I'm broke.. and 600 miles away

 

Man. I’m planning a trip from OK to Montana but not til summer. Wish I could make it up there to snag these.

 

I have a 6 inch lift so I'm interested in them. By the pictures I would assume you don't have much of a step.

 

Yeah the picture is from right after I installed a 3" lift (came out closer to 4" in the back). They hug the body very closely, but enough sticks out that you can get a boot on it. RCI Metalwork' s website has lots more pictures of them if you want to take a look.

 

Thanks, I'll take a look

 

Pm sent.

 

Same

 

Bump - looking to get these out of the garage

 

Would you be willing to drive down to Colorado Springs or even Trinidad? I’m from Amarillo, TX and very interested in these sliders

 

@Dozer knock knock

 

Bump. Get these out of garage

 

Sale pending.

 

Hit me up if the sale falls through.

 

still available?

 

not sure how i missed this post before! if you still have them and they will fit 3rd gen access cab i'll take them, i'm up in summit. i'm going to dig around or email RCI if you still have them to make sure they will fit

 

Not really my place to reply -- but these sliders have been sold (and kick ass): Sorry (#NotSorry)

​

 

Sorry guys - I've been away from TacomaWorld for a bit - I sold them to @nats - impressed to see them installed already!

 

haha no worries! That's what I get for being too slow lol They are lookin good!