What Have You Done To Your 2nd Gen Tacoma Today?

I killed the OEM style switch on a trail today. Only a few hours with them and it fails. Hit a bump, now it doesn’t work. It felt cheap but I didn’t know it was that cheap. Better that it failed now and not when I’m out far wheeling when I actually need light. Going to be replacing it with a rocker switch I found at Oreillys. @CaliRaisedLed

Other than that, the lights are very bright.

 

Updated! More work on the drawers

 

Pulled the trigger on these bad boys.
Loving them so far. Need some advice on leafpack options

 

Ditch brackets mount below the hinge not between hinge and hood.

 

Can anyone post the link to the thread about that Tacoma Rampage in Oregon? Guy running down 3 dudes?

 

It's in the third gen section as you could imagine

https://www.tacomaworld.com/threads...n-runs-over-kids.587698/page-26#post-19639660

 

How about a wash?

 

If you’re looking for or missing any part numbers, I did a write up a few years back for this. Search my name for the thread.

 

Installed Rago stainless steel ditch light brackets and a set of Cali Raised Osram pods today!
https://caliraisedled.com/collections/led-pods-and-work-lights/products/2x2-20w-osram-pod

Ran straight to a SwitchPro until I finally get my auxiliary relay/fuse block wired up. Hope to do that in two weeks.

 

Installed OME 886/90000 HD Dakar’s digging the ride so far next will be Ray10s and 285/75/16 STT Pros!

 

Got some Falken Wildpeaks installed.

 

Found a hole in my frame.

 

Got some DTRLs from @deAutoLED. All I got to say is these things are bright. 100% plug and play, and no hyper flash! Super pumped. This company has been great to work with and their customer service is awesome. I have their reverse lights too, and they are bright as hell.

 

You mean this one: https://www.tacomaworld.com/threads...tion-retrofit-diy-w-info-part-numbers.318616/ ?

I have that saved as a favorite along with two others. One of them is for black interior part numbers such as radio surround and steering wheel controls.

I've looked up so much stuff that I found myself on 4Runner forums and Scion forums.

 

Activated my XM radio and some more parts came in for my nav retrofit. The GPS antenna I ordered was shipped to a dealer in Maine! They said I wouldn't see it until next week. Luckily, it did arrive yesterday and I had to plug it in on my lunch break.
Today I'm going to see what plug is in my tailgate (for the camera) and start figuring out the last of the wiring. I need to run wires from the head unit to the spiral cable, and driver kick panel.

 

Getting ready for the BHLM... using my old ones as practice first

 

Did you install resistors? Part # please.

 

Well....shit.

 

Aironboard.com has switched sized for those spots. Some have modified them to have the typical switches fit but I’d be careful

 

Hope you have a nice little knife to fix that.