1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

(SOLD) 1994 FZJ80 $5000 (Chicagoland)

Discussion in 'Buy / Sell / Trade - Other' started by Snowy, Jan 23, 2019.

Thread Status:
Not open for further replies.
  1. Jan 23, 2019 at 7:39 PM
    #1
    Snowy

    Snowy [OP] Is neither here nor there

    Joined:
    Feb 5, 2014
    Member:
    #122349
    Messages:
    3,372
    Gender:
    Male
    First Name:
    Connor
    Winnebago, IL
    Vehicle:
    3 linked 98 Xtra cab
    Stock-ish
    1994 FJZ80
    -259k - will go up since it is my daily driver on a 50 mile round trip commute
    -Dark Emerald Pearl
    -Non locking axles
    -Manual cloth interior

    I had originally purchased this truck to use as a parts truck for an axle build and help some buddies out that have 80’s and were looking for miscellaneous parts. But once I got the truck home, I realized it was too nice to take off the road...cutting it up and parting it out would have felt a little like shooting a puppy. It was leaking oil from just about every orifice on the engine so I serviced it pretty thoroughly and now I’ve got it up for sale since I really don’t need a fourth vehicle in the driveway. It runs great and I have been enjoying it as a daily on my 50 mile commute to work every day. I wouldn’t hesitate to take it anywhere tomorrow. It would make a great daily driver or a solid foundation to build into a wheeler. From what I can tell it lived in southern Indiana most of its life so rust is minimal and the PO states the HG was done at the dealer around 200k. I have no documentation from him but there's no smoke at idle or after a warm start so I think that the HG and valve seals were done at some point like he said.


    The good:

    -New OEM re-sealed power steering pump
    -New OEM front main seal
    -New OEM valve cover gasket
    -New OEM oil pump o-ring
    -New OEM distributor o-ring
    -New spark plug tube seals
    -Freshly rebuilt knuckles with Marlin inner seals, felts, wipers, hub seals etc.
    -Freshly repacked birfs and wheel bearings
    -New front brakes and newer rear pads.
    -New front KYB Gas-A-Just shocks
    -New plugs
    -PHH has been bypassed
    -Rear heat bypassed
    -Blocked EGR
    -Refinished wheels with Krylon metallic aluminum paint
    -Newer Mastercraft HTR tires
    -Fresh gear oil in both front and rear axles


    -Body is super straight
    -Interior is clean with no evidence of smoking or rips/tears
    -The 1FZ runs great and the plugs were perfect that I took out when I bought the truck. No evidence of any head gasket issues. Pictures of the plugs I took out attached
    -Trans shifts super smooth
    -Goes in and out of low range butter smooth, CDL engages right away
    -Sunroof works perfectly and does not leak
    -Solid frame, no rust except where noted below
    -Headunit has been swapped with an aftermarket double din bluetooth unit
    -I've got a new steering stabilizer and rear shocks that will be included in the sale or I may install if it warms up outside.



    The bad:

    -There is a spot of rust on the driver side front of the rear wheel well
    -There is a quarter sized rust bubble starting on the front of the hood
    -There is some small bubbling on the rear bumper where it is threaded
    -There isn’t much clearcoat left on the roof. Some missing on the cowl too.
    -It is throwing a code 21 for o2 sensors. I just haven’t gotten around to putting new ones in. Runs great unplugged. I didn't remove the PAIR system and install new o2 sensors in the manifold just in case it goes somewhere that requires a visual smog check.
    -Evap canister is bypassed, the original was plugged
    -The power antenna motor/gear is broken, stuck about halfway up
    -It has floppy mirror syndrome on the driver side. Passenger side is solid
    -Could use hood struts and hatch struts. The hood will stay up if it’s not too cold out, hatch stays about half way up.
    -I do not have the key fob
    -I only have 3 out of 4 center caps.

    Asking $5,000 located in Chicagoland

    IMG_6414.jpg

    IMG_6415.jpg

    IMG_6418.jpg

    IMG_6419.jpg

    IMG_6421.jpg

    IMG_6425.jpg

    IMG_6426.jpg

    IMG_6429.jpg

    IMG_6434.jpg

    IMG_6437.jpg

    IMG_6439.jpg

    IMG_6441.jpg

    IMG_6443.jpg

    IMG_6445.jpg

    IMG_6446.jpg

    IMG_6448.jpg

    IMG_6451.jpg

    IMG_6454.jpg

    IMG_6459.jpg

    IMG_6461.jpg

    IMG_6462.jpg

    IMG_6007.jpg

    IMG_6386.jpg

    IMG_6423.jpg
     
    Last edited: Jan 23, 2019
  2. Jan 27, 2019 at 1:05 PM
    #2
    Snowy

    Snowy [OP] Is neither here nor there

    Joined:
    Feb 5, 2014
    Member:
    #122349
    Messages:
    3,372
    Gender:
    Male
    First Name:
    Connor
    Winnebago, IL
    Vehicle:
    3 linked 98 Xtra cab
    Stock-ish
    Bump
     
  3. Feb 14, 2019 at 3:18 PM
    #3
    Robertocritser

    Robertocritser Well-Known Member

    Joined:
    Jul 21, 2010
    Member:
    #40524
    Messages:
    7,216
    Gender:
    Male
    First Name:
    Levi
    KY
    Vehicle:
    08 sport
    ATM6969420 series
  4. Feb 19, 2019 at 3:11 PM
    #4
    Snowy

    Snowy [OP] Is neither here nor there

    Joined:
    Feb 5, 2014
    Member:
    #122349
    Messages:
    3,372
    Gender:
    Male
    First Name:
    Connor
    Winnebago, IL
    Vehicle:
    3 linked 98 Xtra cab
    Stock-ish
Thread Status:
Not open for further replies.

Products Discussed in

To Top