1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Pinion angle after level kit

Discussion in 'Suspension' started by Jeremy2046, Jan 25, 2019.

  1. Jan 25, 2019 at 2:59 PM
    #1
    Jeremy2046

    Jeremy2046 [OP] Member

    Joined:
    Dec 10, 2018
    Member:
    #275416
    Messages:
    16
    Gender:
    Male
    First Name:
    Jeremy
    Vehicle:
    18 tacoma sport
    None
    So I put in a leveling kit, the rear blocks were angled and installed correctly fat end towards back. Since then I’ve had vibration around 28-30 mph and 55 and up. Tires are balanced alignment done checked rear pinion angle vs transfer case angle and it seems I’m about 1.5 degrees out. Is that enough to Cause the vibration??? I’ve also been playing with dropping the hanger bearing right now I’m at 3/4 inch drop. Thoughts? I’m about to take this to a driveline shop to be done with it.
     

Products Discussed in

To Top