Fender/flare trimming

Arent these 37s?

 

Yes he is running 37's.

 

I'm on 37x12.5 stt pros. Wheels are level 8 mk6 17x9 I think -10mm offset. I also running 1.25 inch wheel spacers on all 4 reason for wheel spacers is to run chains in the front wiithou hitting my uca.

I removed my fender liners on all 4 and trimmed the actual fender about 1 inch away from where your stock flares goes on to. And then I trimmed my flares to match it. I just used zip ties to hold them on. I originally got new clips for them but they broke. The zip ties hold up really well.

I ended up getting a Hilux 167 snorkel for since since no fender liners. Kept on kicking up dirt and rocks into my filter. The whole snorkel and everything costed me under $200 all said and done.

I hammered back my pinch well and the whole inside as far back as I can. Also hammer vack more then just pinch weld as you can tell in some of my pictur s. I chopped off my cab mount as far back as I could also.

 

I am regeared to 4.88s it's perfect for me. Also have a pedal commander wayy better throttle repsobse.

At 60mph my rpms are at 2k

 

Also once you trim the flares. Put trim lock edge on it. It'll cover up the edges and gives it a cleaner look. Plus cover up most of imperfections of the cuts.

 

noooo go away with your 37s.. I want 37s, but id need to regear again and probably add a crawl box to save my clutch 4cyl problems

 

Yeah might needed with the 4cyl

 

Is it possible to run 35s w chains (v bar chains ideally)?

 

on the rear sure, the front is no beuno unless you get some distance between the tire and the uca

 

I ran them when I had 35s chained up all 4 tires also aired down to 8psi. non v bar though.

 

I swear Oregon is like awesome Toyota heaven... last may when I was there it seemed every time we turned a corner there was another one

 

whats the spec on your wheels?

 

17x8.5 0 offset Pro Comp 5029

 

Thanks Saechao503 for the info and awesome truck.

 

Thanks! Anytime glad I can help out

 

How did you do this? I think all I can do is my 285/70R16s which are the same height as 265s... Unless there's some secret

 

You don't drive anywhere

 

Lol

 

You didn’t trim anything and your getting no rub?

I’m running the same size tires as you but I had slight rubbing so I cut out about 2” on the inner fender. I still rub when wheeling and at an angle. I think it’s because my stock shocks are shot so my trucks “sagging” lmao. Since I need new shocks I’m planning on lifting the truck 2.5-3” at the same time. Waiting for dealer to replace my leaf springs and propeller shaft/u joints for recall and then gonna change out shocks/lift.

 

No rub or modification to cab mount. I had to slightly trim the lower part of the flare and heat gun the black liner.